KitchenAid KUDF204KPA Owners Manual - Page 6

Installation, Instructions

Page 6 highlights

Top and bottom overlay drawer panel dimensions: Upper Door 11/16" (1.75 cm) 3/4" (1.9 cm) 233/4" (60.3 cm) 223/8" (56.8 cm) Top 13/16" (2.05 cm) 11/16" (1.75 cm) Electrical Requirements Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 137/16"" (34.2 cm) 15" (38 cm) Lower Door 11/16" (1.75 cm) 3/4" (1.9 cm) Bottom Pilot hole 4 places 233/4" (60.3 cm) 223/8" (56.8 cm) Top 11/16" (1.75 cm) 11/16" (1.75 cm) 11/16" (1.75 cm) Before you move your double drawer into its final location, it is important to make sure you have the proper electrical connection. Recommended grounding method: A 115 V, 60 Hz, AC only, 15 A or 20 A fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your double drawer be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord. NOTE: Before performing any type of installation, cleaning, or removing a light bulb, unplug the double drawer or disconnect power. INSTALLATION INSTRUCTIONS Unpack the Refrigerator Drawers 1213/16" (32.6 cm) 15" (38 cm) Bottom Pilot hole 4 places 17/16" (3.65 cm) Excessive Weight Hazard Use two or more people to move and install or uninstall appliance. Failure to do so can result in back or other injury. 6 05-May-2021 10:43:59 EDT | RELEASED Before using your double drawer, all packaging materials should be removed and the interior should be cleaned. Remove tape and glue residue from surfaces before turning on the double drawer. With your fingers, rub a small amount of liquid dish soap over any adhesive and wipe with warm water to remove. Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These can damage the surfaces of your double drawer. For more information, refer "Double Drawer Safety" section. In some European factories the letter "W" of the part code mentioned herein will be automatically replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52

Top and bottom overlay drawer panel dimensions:
Electrical Requirements
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your double drawer into its final location,
it is important to make sure you have the proper electrical
connection.
Recommended grounding method:
A 115 V, 60 Hz, AC only, 15 A or 20 A fused, grounded
electrical supply is required. It is recommended that a
separate circuit serving only your double drawer be provided.
Use an outlet that cannot be turned off by a switch.
Do not use an extension cord.
NOTE:
Before performing any type of installation, cleaning, or
removing a light bulb, unplug the double drawer or
disconnect power.
INSTALLATION
INSTRUCTIONS
Unpack the Refrigerator Drawers
Excessive Weight Hazard
Use two or more people to move and install or uninstall
appliance.
Failure to do so can result in back or other injury.
Before using your double drawer, all packaging materials
should be removed and the interior should be cleaned.
±
Remove tape and glue residue from surfaces before turning
on the double drawer. With your fingers, rub a small amount
of liquid dish soap over any adhesive and wipe with warm
water to remove.
±
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue.
These can damage the surfaces of your double drawer.
For more information, refer “Double Drawer Safety” section.
6
Bottom
15” (38 cm)
13/16”
(2.05 cm)
11/16”
(1.75 cm)
Top
11/16”
(1.75 cm)
13
7
/
16
”” (34.2 cm)
11/16”
(1.75 cm)
Pilot hole 4 places
3/4”
(1.9 cm)
22
3
/
8
” (56.8 cm)
23
3
/
4
” (60.3 cm)
Bottom
15” (38 cm)
11/16”
(1.75 cm)
11/16”
(1.75 cm)
Top
11/16”
(1.75 cm)
12
13
/
16
” (32.6 cm)
1
7
/
16
(3.65 cm)
Pilot hole 4 places
3/4”
(1.9 cm)
22
3
/
8
” (56.8 cm)
23
3
/
4
” (60.3 cm)
Upper Door
Lower Door
05-May-2021 10:43:59 EDT | RELEASED
In some European factories the letter "W" of the part code mentioned herein will be automatically
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")