Konica Minolta Cube Cube3 Quick Start Guide - Page 21

NOTE: To install the print pad, place it on top

Get Konica Minolta Cube PDF manuals and user guides View all Konica Minolta Cube manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

NOTE: Follow the instructions on the screen. Use the included 1.5 mm Allen wrench to loosen the set screws securing the adjustment knobs to the bracket before turning the knobs. Select the checkmark to continue. You will be prompted to perform the Auto Level procedure again. NOTE: The set screw for knob A can be accessed from behind the printer. The set screw for knob B can be accessed from the front of the printer. NOTE: Once adjustments have been completed, tighten the set screws before continuing. 23. It is recommended that Auto Gap is performed after performing the Auto Level procedure. Ensure the print pad is clean and installed properly and then select the checkmark to continue to Auto Gap. NOTE: To install the print pad, place it on top of the adjustment knobs. When the print pad is centered properly, the magnets will secure the print pad to the printer. NOTE: The printer will perform an automated gap measurement. 18

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
18
NOTE: Follow the instructions on the screen.
Use the included 1.5 mm Allen wrench to loosen
the set screws securing the adjustment knobs to
the bracket before turning the knobs. Select the
checkmark
to continue. You will be prompted to
perform the Auto Level procedure again.
NOTE: The set screw for knob A can be
accessed from behind the printer. The set screw
for knob B can be accessed from the front of the
printer.
NOTE: Once adjustments have been completed,
tighten the set screws before continuing.
23.
It is recommended that Auto Gap is performed after
performing the Auto Level procedure. Ensure the print
pad is clean and installed properly and then select the
checkmark
to continue to Auto Gap.
NOTE: To install the print pad, place it on top
of the adjustment knobs. When the print pad is
centered properly, the magnets will secure the
print pad to the printer.
NOTE: The printer will perform an automated
gap measurement.