Konica Minolta Cube Cube3 Quick Start Guide - Page 27

Maintenance

Get Konica Minolta Cube PDF manuals and user guides View all Konica Minolta Cube manuals
Add to My Manuals
Save this manual to your list of manuals

Page 27 highlights

MAINTENANCE PRINT PAD MAINTENANCE Auto Level and Auto Gap can be affected by a residual glue or print material adhered to the print pad. These procedures can also be affected by a print pad that is too shiny. 1. Select PLATE MAINTENANCE. 2. Remove the print pad. NOTE: The print pad is magnetically attached to the adjustment knobs. 3. Using the fine-grit sandpaper, buff the print pad. NOTE: Refer to the section titled Clean The Print Pad for specific instructions. NOTE: Ensure the print pad is clean and dry before installing it in the printer. 4. Select the checkmark to continue. 5. Perform the Auto Level and Auto Gap procedures. 24

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
24
MAINTENANCE
PRINT PAD MAINTENANCE
Auto Level and Auto Gap can be affected by a residual glue or print material adhered to the print pad.
These procedures can also be affected by a print pad that is too shiny.
1.
Select
PLATE MAINTENANCE
.
2.
Remove the print pad.
NOTE: The print pad is magnetically attached to
the adjustment knobs.
3.
Using the fine-grit sandpaper, buff the print pad.
NOTE: Refer to the section titled Clean The Print
Pad for specific instructions.
NOTE: Ensure the print pad is clean and dry
before installing it in the printer.
4.
Select the
checkmark
to continue.
5.
Perform the Auto Level and Auto Gap procedures.