Konica Minolta Cube Cube3 Quick Start Guide - Page 26

Finishing Your Creation

Get Konica Minolta Cube PDF manuals and user guides View all Konica Minolta Cube manuals
Add to My Manuals
Save this manual to your list of manuals

Page 26 highlights

FINISHING YOUR CREATION REMOVING YOUR CREATION FROM THE PRINT PAD 1. Remove the print pad and place it in a container filled with warm tap water. Allow it to soak for approximately ten minutes or until your creation can be easily removed from the print pad. After it has soaked, gently pry the creation from the print pad using the included scraper. Caution: Always move the scraper away from the body. The scraper can cause injury if not used correctly. Caution: Exercise caution when using a tool to remove a part from the print pad. The print pad can become damaged if the tool is not used properly. 2. Clean the glue from the print pad by rinsing it under tap water. 3. Dry the print pad with a lint-free cloth. REMOVING SUPPORTS AND RAFTS (IF REQUIRED) 1. Use small pliers to remove supports and rafts. NOTE: In places where the supports are inside your creation, and are difficult to reach, use small wire cutters (not supplied) to remove the supports. 23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
23
FINISHING YOUR CREATION
REMOVING YOUR CREATION FROM THE PRINT PAD
1.
Remove the print pad and place it in a container filled with warm tap water. Allow it to soak for
approximately ten minutes or until your creation can be easily removed from the print pad. After it
has soaked, gently pry the creation from the print pad using the included scraper.
Caution: Always move the scraper away from the body. The scraper can cause
injury if not used correctly.
Caution: Exercise caution when using a tool to remove a part from the print pad.
The print pad can become damaged if the tool is not used properly.
2.
Clean the glue from the print pad by rinsing it under tap water.
3.
Dry the print pad with a lint-free cloth.
REMOVING SUPPORTS AND RAFTS (IF REQUIRED)
1.
Use small pliers to remove supports and rafts.
NOTE: In places where the supports are inside your creation, and are difficult to reach,
use small wire cutters (not supplied) to remove the supports.