Konica Minolta Cube Cube3 Quick Start Guide - Page 28

Perform Auto Level and Auto Gap Procedures.

Get Konica Minolta Cube PDF manuals and user guides View all Konica Minolta Cube manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

Clean The Print Pad 1. Remove the print pad from the printer. 2. Wash all glue and print material from the print pad with warm tap water. If necessary, scrub the print pad with a soft brush. 3. Dry the print pad thoroughly. 4. If residual print material is still adhered to the print pad, gently use the scraper to remove it. Refer to the User Guide for more information. 5. Using the included fine-grit sandpaper, lightly sand the print pad left-to-right in .5" (12.7 mm) swirling motions until the entire print pad has been treated. NOTE: It is most important to gently sand all shiny parts of the print pad so the print pad surface appears matte in texture. 6. Clean and dry the print pad thoroughly. 7. Reinstall the print pad with the Cube symbol (A) on the front of the print pad aligned the Cube symbol (B) on print platform. A B 8. Perform Auto Level and Auto Gap Procedures. 25

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
25
Clean The Print Pad
1.
Remove the print pad from the printer.
2.
Wash all glue and print material from the print pad with warm tap water. If necessary, scrub the
print pad with a soft brush.
3.
Dry the print pad thoroughly.
4.
If residual print material is still adhered to the print pad, gently use the scraper to remove it. Refer
to the User Guide for more information.
5.
Using the included fine-grit sandpaper, lightly sand the print pad left-to-right in .5” (12.7 mm)
swirling motions until the entire print pad has been treated.
NOTE: It is most important to gently sand all shiny parts of the print pad so the print
pad surface appears matte in texture.
6.
Clean and dry the print pad thoroughly.
7.
Reinstall the print pad with the Cube symbol (A) on the front of the print pad aligned the Cube
symbol (B) on print platform.
8.
Perform Auto Level and Auto Gap Procedures.
A
B