Konica Minolta bizhub C360 LK-101/LK-102/LK-103/LK-105 License Authentication - Page 75

for Customer Engineer Operation procedure when executing particular operation 1. When using the License already activated on the other MFP, (Refer to fig. below) a. Deactivate the License on the MFP A. b. After the deactivation made on MFP A, it is possible to activate the License again on MFP B. ¾ Do not execute Initialization for this purpose, especially on the MFP with License activated. (MFP A) (Please make sure to execute Deactivation.) If executing Initialization, the following operation is required to transfer the License to the other MFP. i. Activate the License on MFP A once. (The License needs to be activated on MFP A.) ii. Deactivate the License. Then it is possible to use deactivated license on other MFP B. a License Transfer b License Deactivation Activation MFP A MFP B 2. When replacing NVRAM with a new one, If replacing NVRAM, please make sure to use the new one. License Management error will occur. The following operation is required to solve that error. ¾ If the license is activated, a. execute Repair b. execute Activation after Repair ¾ If the license is NOT activated, a. execute Repair b. If Repair is not completed correctly, then execute Initialization. Issued by BT-CSO 75 Ver 1.0x