Konica Minolta bizhub C3850FS bizhub C3850FS/C3850/C3350 Maintenance/Troublesh - Page 83

4.9 Major messages and actions 4 Message [Paper Size Mismatch] [Paper Empty] [Paper Size/Type Mismatch] [Output Tray Full] [Memory Overflow] [No more staples.] [Stored Job Error] [HDD Capacity Over] [Document Registration Overload] [Memory Full (FAX)] [ADF Initialize Error] [Check Scanner Lock Lever] [Job Registration Limit Over] [Connection Failed] [Writing Error] [Matching paper size not available.] Description Paper of the specified size is not loaded into a tray. A print job was executed by specifying the Manual Feed Tray from the printer driver, but no paper was loaded in the Manual Feed Tray. A print job was executed by specifying Tray X from the printer driver, but no paper was loaded in Tray X. The size and type of the paper loaded in the tray specified from the printer driver are different from those of the paper loaded in the tray on the main unit. The size and type of the paper in the tray that are specified on the Control Panel do not match those of the paper actually loaded in the tray. The amount of paper output to the Output Tray has reached the maximum. Data has been received over the maximum memory size. All the available space in memory has been used up by document scanning. Staples have run out. The option configuration is different from that specified when a job was saved. The HDD capacity has become full. The number of files on the HDD has reached the upper limit. The fax data storage area has become full. The ADF cover is not set securely. The Scanner Lock Lever is locked. The number of registered jobs has reached the upper limit. Failed to connect to the FTP server. An error has occurred while saving data onto a USB memory device. Paper appropriate for a print job is not loaded in the tray. Remedy Load the correct paper into the displayed tray. Load paper into the Manual Feed Tray. Load paper into Tray X. Load the paper of the appropriate size and type into the tray, then specify the correct size and type for the loaded paper on the Control Panel. Load the paper of the appropriate size and type into the tray, then specify the correct size and type for the loaded paper on the Control Panel. Remove the paper from the Output Tray. Cancel the job to reduce the amount of data, then execute the job again. Reduce the amount of original data. Replace the Staple Cartridge. For details, refer to page 2-27. Return to the option configuration specified when a job was saved. Delete data saved on the HDD, if necessary. Delete data saved on the HDD, if necessary. When sending fax data, send only the scanned original, or manually send it again. When receiving fax data, print or delete data saved in memory. Open the ADF cover once, then close it again. Cancel the job, then release the Scanner Lock Lever. Wait until a job has been completed, or delete a current job. Check that the destination has been registered correctly. Cancel the job, then check that the USB memory is in the write enable state. Load the appropriate paper in the tray, then specify the correct size and type for the loaded paper on the Control Panel. [Maintenance/Troubleshooting] 4-19