LG 26LH1DC5 Owner's Manual - Page 71
Cloning Procedure Troubleshooting
View all LG 26LH1DC5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
CLONING PROCEDURE TROUBLESHOOTING IMPORTANT INSTALLER SETUP INFORMATION! PLEASE READ THE FOLLOWING... Warning: Do not use LT2002 while a LodgeNet PPV card is installed in TV or clone programmer will be damaged. Reset Clone After Static Shock After replacing exhausted batteries, or if the programmer behaves strangely after a static shock, activate the internal reset switch and restore normal operation. After a reset, check the real-time clock setting. It may be necessary to reset the Clone Programmer clock from a TV containing the correct time. *Note: The LT2002 programmer is designed to be used with TVs containing the 221-01006 and later processors. Use with earlier TV sets may give unpredictable results. Processors used before the 221-01006-04 have a limited screen display capability. They cannot display entire screens as shown in the quick setup instructions accompanying the LT2002 clone programmer. Use the printed menu illustrations on the quick setup sheet supplied with the Clone as an aid to making your programming choices. (Although the menus are not all displayed, the clone functions all operate normally.) Remote does not operate clone. Wrong Installer remote. 8 Only use an appropriate Installer remote to operate clone programmer with 26LH1DC3/4/5. LED does not blink M.P.I. cord not connected. 8 Connect M.P.I. cord. 26LH1DC3/4/5 not turned on. 8 26LH1DC3/4/5 must be powered On for clone to work. Weak batteries. 8 Install 4 fresh AA high-quality alkaline batteries. Clone menu hard to read. Weak signal. 8 Connect 26LH1DC3/4/5 to a reliable Analog channel signal source. No time set. Time not available. 8 Set time on a TV, copy time to Clone Programmer. APPENDIX 71