LG 26LH1DC5 Owner's Manual - Page 76

APPENDIX INSTALLER QUICK SETUP GUIDE Quick Setup Guide for Integrated Master TVs See table of contents for more information. APPENDIX 76 Antenna Wall Jack RF Coaxial Wire (75ohm) AC Power Cord LODGING PTC INSTALLER MENU 000 INSTALLER SEQ 000 UPN 000-000-000-000 FPGA 09F1 PTC V1.00.000 CPU V1.01.00 117 FACT DEFAULT 00X 003 BAND/AFC 00X 028 CH.OVERIDE 001 Mode Standard G Color Temperature Cool Screen Format 16:9 Noise Reduction Off Film Mode Off 11:20 PM Sep.11, 2006 D E Move OK Select Menu Back Mode Standard G Color Temperature Contrast 100 Screen Format Brightness 79 Noise Reduction Sharpness 65 Film Mode Color 70 Tint 0 11:20 PM Sep.11, 2006 D E Move OK Select Menu Back Setup Instructions for Making a Master TV 1. Connect TV to signal source, connect power cord and turn TV power on. 2. Enter the TV installer menu. *Note: If this is not a new setup, set Installer item 117 to 001 and press Enter to reset TV to default condition. • Set Tuning Band. Set Installer menu item 003 BAND/AFC to CATV: 001, Broadcast: 000 etc. • If necessary, set Installer menu item 028 CH OVERIDE to 001. In addition, set any other installer items as required of your system. Exit Installer menu. 3. Access the Master TV menus and set the closable options on the menus to the desired configurations. Refer to the Closable Menu Features Chart for the TV. (Picture, Sound, Time etc.) 4. Do a Channel Search; run Auto Program. (aka EZ Scan.) 5. Enter the Channel Edit menu and delete channels per your requirements. 6. Enter the Channel Label menu and assign ICONs to the channels. *Note: You can add Channel ICONS typically network logos like ABC, NBC, PBS etc. in this step. Or, in Step 8, add Channel ICONS or custom text labels for channels which no Icons are available for. 7. Transfer the TV setup. After all menu options and features are set to your requirements, enter the installer menu. Press '2', '5', '5', 'MENU' to start the transfer of the TV's setup to the PTC. After the transfer is complete, the system will exit the Installer menu. 8. Set any Channel Labels as needed. a. Enter Installer menu. b. Press '2', '5', '4', 'MENU' to enter the menu. In this menu edit the assigned channel Icons, assign custom text labels for channels and assign labels for active Aux sources. Press 'Menu' to exit. 9. Enter the Installer menu. Set item 028 Ch Overide to 000 and exit menu. 028 CH.OVERIDE 000 DIGITAL 19-3 MONO STEREO SAP ANALOG 2 WXYZ MONO WXYZ Antenna Auto Program G Channel Label Channel List Fine Tune Auto Signal Strength D E Move OK Select Menu Back Antenna Auto Program Channel Label Channel List Fine Tune Signal Strength Menu Back