LG WM3885HCCA Owner's Manual - Page 12
Connecting The Water Lines
UPC - 048231011044
View all LG WM3885HCCA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
INSTALLATION INSTRUCTIONS CONNECTING THE WATER LINES • IMPORTANT: Use new hoses when installing the washer. Do NOT reuse old hoses. • IMPORTANT: Use ONLY the inlet hoses provided by LG with this laundry product. Aftermarket hoses are not guaranteed to fit or function correctly. Other hoses may not tighten correctly and could cause leaks. Subsequent damage to product or property will not be covered under the terms of LG's warranty. • Water supply pressure must be between 14.5 PSI and 116 PSI (100~800 kPa). If the water supply pressure is more than 116 PSI, a pressure reducing valve must be installed. • Periodically check the hose for cracks, leaks, and wear, and replace the hose if necessary. • Make sure that the water lines are not stretched, pinched, crushed, or kinked. • The washer should never be installed or stored in a location subject to freezing temperatures. Damage to the water lines and internal mechanisms of the washer can result. If the washer was exposed to freezing temperatures prior to installation, allow it to stand at room temperature for several hours before use. Water Inlets 2 NOTE: Do not cross-thread the hose fittings. Attach the hot water line to the red hot water inlet on the back of the washer. Attach the cold water line to the blue cold water inlet on the back of the washer. Tighten the fittings securely. Water Hose (to water inlet on washer) Rubber Seal Water Tap Rubber Seal Water Hose (to tap) 1 Insert a rubber seal into the threaded fittings on each hose. 12 3 Attach the hot water line to the hot water tap. Attach the cold water line to the cold water tap. Tighten the fittings securely. Open the water taps fully to check for leaks.