Lenovo ThinkCentre A62 Hardware Maintenance Manual - Page 46
User Password, Administrator Password, Setting, changing, and deleting a password
View all Lenovo ThinkCentre A62 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
• Contain at least one alphabetic character and one numeric character • Setup Utility program and hard disk drive passwords are not case sensitive • Not be your name or your user name • Not be a common word or a common name • Be significantly different from your previous password User Password When a User Password is set, the computer cannot be used until a valid password is typed from the keyboard. Administrator Password When an Administrator Password is set, it deters unauthorized persons from changing configuration settings. If you are responsible for maintaining the settings of several computers, you might want to set an Administrator Password. After you set an Administrator Password, a password prompt is displayed each time you try to access the Setup Utility program. If both the user and administrator passwords are set, you can type either password. However, to change any configuration settings, you must use your administrator password. Setting, changing, and deleting a password To set, change, or delete a password, do the following: Note: A password can be any combination of up to twelve alphabetic and numeric characters (a-z and 0-9). For more information, see "Password considerations" on page 39. 1. Start the Setup Utility program (see Chapter 6 "Using the Setup Utility" on page 39). 2. From the Setup Utility program menu, select Security. 3. Based on your need, select Set User Passwords or Set Administrator Passwords. 4. Read the information displayed on the right side of the screen. Enabling or disabling a device You can enable or disable user access to a device. SATA 1 OnBoard Floppy Controller When this feature is set to Disable, all devices connected to the SATA controller (such as hard disk drives or the CD-ROM drive) are disabled and will not be displayed in the system configuration. When this feature is set to Disable, the diskette drive cannot be accessed. To set the SATA 1, do the following: 1. Start the Setup Utility program (see "Starting the Setup Utility program" on page 39). 2. From the Setup Utility program menu, select Devices ® SATA Drives Setup ® SATA 1 and press Enter. 3. Select 32 Bit Data Transfer. 4. Select the desired settings and press Enter. 5. Return to the Setup Utility program menu and select Exit ® Save Changes and Exit. Note: If you do not want to save the settings, select Discard Changes or Discard Changes and Exit. 40 ThinkCentre Hardware Maintenance Manual