Lenovo ThinkPad 365E-ED ThinkPad 365, SelectaDock I - Hardware Maintenance Man - Page 362
For Model 760CD, 760ED, 760LD, 760ELD, 760XL
View all Lenovo ThinkPad 365E-ED manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 362 highlights
4. Disconnect the AC Adapter, remove the hard disk and diskette drive, and install the charged battery pack; then check that power is supplied by the battery pack. If you suspect a power problem, see the appropriate power supply check in the following list: "Checking the AC Adapter." "Checking Operational Charging" on page 351. "Checking the Battery Pack" on page 351. "Checking the Car-Battery Adapter" on page 352. "Checking the Backup Battery" on page 353. "Checking the Standby Battery" on page 354. "Port Replicator Power Overload" on page 358. Checking the AC Adapter: You are here because the computer fails only when the AC Adapter is used. If the power problem occurs only when the port replicator is used, replace the replicator. If the power-on indicator does not turn on, check the power cord of the AC Adapter for correct continuity and installation. If the operational charge does not work, go to "Checking Operational Charging" on page 351. Note: For Model 760CD, 760ED, 760LD, 760ELD, 760XL, and 760XD, there are two types of adapters. The procedure for checking both types is the same. 1. Unplug the AC Adapter cable from the computer and measure the output voltage at the plug of the AC Adapter cable. See the following figure: (20 - 10 V) 21 Pin Voltage (V dc) 1 +18.0 to +21.0 2 Ground (16 - 10 V) Pin Voltage (V dc) 1 +14.5 to +17.0 2 Ground If the voltage is correct, make sure the connection between DC/DC card and system board is not loose. 350 IBM Mobile Systems - ThinkPad HMM Volume 3