Lenovo ThinkPad 365E-ED ThinkPad 365, SelectaDock I - Hardware Maintenance Man - Page 569
How to Run the Diagnostics
View all Lenovo ThinkPad 365E-ED manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 569 highlights
Note: If the replaced parts did not resolve the problem, put the original parts back in the IBM ThinkPad Dock I. Do not replace non-defective parts. a. Keyboard cable b. Main card of IBM ThinkPad Dock I How to Run the Diagnostics Use either the TrackPoint III or the cursor move keys to interact with the tests. The Enter key works the same as selecting the OK icon to reply OK. 1. Press and hold the F1 key; then power-on the computer. Hold the F1 key down until the Easy-Setup screen appears. 2. Select Test and press Enter. 3. Select a device and press Enter to run the test. 4. The test progress screen appears. 5. OK appears when the test ends without any errors. 6. Start the Advanced Diagnostic test by pressing Ctrl+A on the basic diagnostic menu screen. 7. Select Tool to install the tools. 8. Select a device, press the Spacebar and install the tool. Multiple devices can be selected by repeating this step. A √ mark appears beside the selected devices. 9. Select OK and press Enter if the selection is OK. 10. Select a device and press Enter to start the tests. 11. Select Test All to test all devices. 12. Select Loop Test to run the tests in a repeated loop. A loop option menu appears in which a device loop or all-device loop can be selected. Select a device and press the Spacebar to select a device. Repeat this step to select multiple devices. Press Enter to start the diagnostic loop. If no device is selected, all device tests are looped. 13. To exit the loop, keep pressing Ctrl+Pause until the test exits. A beep sounds to notify that the exit interrupt is sensed by the test program. Error Log: Diagnostic errors are printed on the printer that is attached to parallel port when the error is detected. The error is also logged in the system memory. Use the following procedure to display the errors. 1. End the test, if it is running. 2. Press Ctrl+A to select the advanced diagnostic mode. 3. Press Ctrl+E. 4. The error log appears. 5. To exit the screen, select the cancel icon or press Esc. The error log is not saved when system power is turned off. ThinkPad SelectaDock Docking System 557