Lexmark 4600 T64x - Menus and Messages Guide - Page 111
Restart job, Cancel Job, Scan from Automatic Document Feeder, Scan from flatbed
View all Lexmark 4600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
Understanding MFP messages Message Meaning Action Replace all originals if restarting job. One or more messages that interrupted a scan job are now cleared. Replace the original documents in the scanner to restart the scan job. Touch Restart job if job level recovery is active and the job is restartable. The message clears. A new scan job containing the same parameters as the previous job starts. Touch Cancel Job if a scan job is processing when the attendance message appears. This cancels the job and clears the message. Touch Scan from Automatic Document Feeder if the page jam recovery is active. Scanning resumes from the ADF immediately after the last successfully scanned page. Touch Scan from flatbed if page jam recovery is active. Scanning resumes from the flatbed immediately after the last successfully scanned page. Touch Finish job without further scanning if page jam recovery is active. The job ends at the last successfully scanned page, but the job is not canceled. Successfully scanned pages go to their destination: copy, fax, e-mail, or FTP. Replace jammed originals if restarting job. One or more messages that interrupted a scan job are now cleared. Replace the original documents in the scanner to restart the scan job. Touch Restart job if page level recovery is active and the job is restartable. The message clears. A new scan job containing the same parameters as the previous job starts. Touch Cancel Job if a scan job is processing when the attendance message appears. This cancels the job and clears the message. Touch Scan from Automatic Document Feeder if the page jam recovery is active. Scanning resumes from the ADF immediately after the last successfully scanned page. Touch Scan from flatbed if page jam recovery is active. Scanning resumes from the flatbed immediately after the last successfully scanned page. Touch Finish job without further scanning if page jam recovery is active. The job ends at the last successfully scanned page, but the job is not canceled. Successfully scanned pages go to their destination: copy, fax, e-mail, or FTP. Replace wiper The MFP detects that the fuser wiper needs to be replaced. 1 Replace the fuser wiper. 2 Touch Continue to clear the message. Touch Ignore to clear the message, but at the next power-on, the message appears again. Restore held jobs? Held jobs are found on the hard disk after a power-on reset of the MFP. Touch Yes to restore the held jobs to the hard disk and make them available. The jobs data remains on the hard disk; however, the job control information is stored in the MFP memory. Touch Quit to stop restoring held jobs before all jobs are restored. Unrestored jobs remain on the hard disk and are retrievable again only at the next power-on reset. Note: A pop-up screen appears to indicate Restoring held jobs(s) xxx/yyy, where xxx indicates the number of the current job being restored, and yyy is the total number of jobs to be restored. Touch Do not restore to have the held jobs remain on the hard disk until they are deleted. Attendance messages 111