Lexmark E312L User's Guide - Page 33
Plug the power cord into the printer., metal clips.
View all Lexmark E312L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
When you have finished installing the option card(s): 1 Fit the metal shield into the slots and reattach the screws. 2 Put the printer back to its original upright position. 3 Re-install the print cartridge. 4 Reconnect the computer cable and latch the metal clips. 5 Plug the power cord into the printer. 6 Turn the printer on. As the printer powers up and the operator panel lights begin cycling on and off, there is a pause while the new memory is tested, then the lights continue cycling. 7 When the Ready light comes on, press the operator panel button briefly and print a test page to verify that printer memory or additional flash memory is installed. If the Ready light does not come on, see Printing problems. 20 Chapter 1: The basics
20
Chapter 1: The basics
When you have finished installing the option card(s):
1
Fit the metal shield into the slots and reattach
the screws.
2
Put the printer back to its original upright
position.
3
Re-install the print cartridge.
4
Reconnect the computer cable and latch the
metal clips.
5
Plug the power cord into the printer.
6
Turn the printer on.
As the printer powers up and the operator panel
lights begin cycling on and off, there is a pause
while the new memory is tested, then the lights
continue cycling.
7
When the Ready light comes on, press the
operator panel button briefly and print a test
page to verify that printer memory or additional
flash memory is installed.
If the
Ready
light does not come on, see
Printing
problems
.