Lexmark T430 Setup Guide - Page 31
Reattaching the shield and side cover, and front of the cover into their
 |
View all Lexmark T430 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Reattaching the shield and side cover After installing memory or firmware cards, you must reattach the shield and side cover. 1 Align the five keyholes on the shield with the five screws on the system board. 2 Press the shield against the system board, and then slide the shield to the right. 3 Tighten the five screws. 4 Align the three rear tabs on the side cover with the corresponding slots on the printer. 5 Guide the tabs on the top, bottom, and front of the cover into their corresponding slots. The top and front tabs snap into place. 6 Close the upper front door and the multipurpose feeder door. Make sure both doors snap closed on both sides. Install printer memory or firmware cards 21
-
1 -
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26 -
27 -
28 -
29 -
30 -
31 -
32 -
33 -
34 -
35 -
36 -
37
-
38
-
39
-
40
-
41
-
42
-
43
-
44
-
45
-
46
-
47
-
48
-
49
-
50
-
51
-
52
-
53
-
54
-
55
-
56
-
57
-
58
 |
 |
21
Install printer memory or firmware cards
Reattaching the shield and side
cover
After installing memory or firmware
cards, you must reattach the shield and
side cover.
1
Align the five keyholes on the
shield with the five screws on the
system board.
2
Press the shield against the
system board, and then slide the
shield to the right.
3
Tighten the five screws.
4
Align the three rear tabs on the
side cover with the corresponding
slots on the printer.
5
Guide the tabs on the top, bottom,
and front of the cover into their
corresponding slots.
The top and front tabs
snap
into
place.
6
Close the upper front door and the
multipurpose feeder door.
Make sure both doors
snap
closed
on both sides.