Lexmark T522 Service Manual - Page 197
Fuser Lamp Removal, Fuser Lower Exit Guide Assembly Removal
UPC - 734646620642
View all Lexmark T522 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 197 highlights
4520-xxx Fuser Lamp Removal 1. Remove the fuser assembly. 2. Disconnect the fuser lamp AC cable from the top cover assembly. 3. Remove the fuser lamp. Warning: Hold the left lamp bracket and carefully remove the two mounting screws. There is pressure against the other end of the lamp therefore care must be used when removing the lamp from the fuser. Grip the lamp by the ceramic end piece and remove it from the fuser assembly. Be careful not to touch the glass as skin oils and acids can reduce the life of the lamp. Use the following table to identify and install the correct lamp. Description Fuser Lamp 115V 630W Fuser Lamp 220V 630W Fuser Lower Exit Guide Assembly Removal 1. Remove the fuser assembly. 2. Remove the fuser cover assembly. 3. Remove the fuser detack housing assembly. 4. Disconnect the sensors from the fuser board. 5. Gently apply outward pressure on the left and right fuser side frames to release the lower exit guide assembly. Repair Information 4-35