Lexmark T522 Service Manual - Page 55
Smart Contact Assembly Service Check on,
UPC - 734646620642
View all Lexmark T522 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
4520-xxx User Error Message Explanation 32 Unsupported Print Cartridge 34 Short Paper 36 Resolution Reduced Error 32 is displayed when the top cover is closed and an unsupported print cartridge is detected. It may take the printer 10-20 seconds to determine if the print cartridge is supported. Depending on the setting of the Machine Class ID the printer may be allowed to print pages during this 10-20 second interval. If pages are allowed to print, then they are not reprinted once a good print cartridge is inserted. If this does not fix the problem, go to the "Smart Contact Assembly Service Check" on page 2-100. The printer determines the paper length is too short to print the formatted data. This occurs when the printer does not know the actual paper size loaded in the tray. For auto-size sensing trays, this error occurs if the paper stop is in the incorrect position. Make sure the Paper Size setting is correct for the size paper that is being used. The resolution of the page has been reduced from 600 dpi to 300 dpi to prevent a Memory Full error. This message can only occur if the Resolution Reduction setting is turned on. 37 Insufficient Collation Memory 38 Memory Full 39 Complex Page 51 Defective Flash Note: 1200 dpi pages are not resolution reduced. If a 1200 dpi job runs out of memory, a Memory Full error is displayed. This message is displayed when the printer memory used to store pages is too full to collate the print job. This message is displayed when the printer memory used to store pages is full. This message is displayed when the page is too complex to print. This message is displayed when the printer detects a defective flash. This error may occur at power on, or during flash format and write operations. Press Go to clear the message. The flash is marked as bad and normal operation continues. Flash operations are not allowed until the problem is resolved. Diagnostic Information 2-27