LiftMaster HDSW24UL Installation Manual - English - Page 24

INSTALLATION Step 11 Install the Cover Before installing the cover, follow the instructions in the Adjustment section to adjust the limits and force. The operator cover consists of two pieces: a rear cover and a front cover. The front cover can easily be removed to access the electrical box. Slide the access door up to access the reset switch. The front cover and access door can be locked with the key. 1. Remove the operator arm from the output shaft by releasing the handle. 2. Place the rear cover over the operator. 3. Secure both sides of the rear cover to the chassis with the provided screws. 4. Reattach the operator arm to the output shaft (making sure the pin fits into the slot) and secure by pushing the handle down. 5. Place the top (cludge) cover over the operator arm and secure. 6. Align the front cover with the back cover and fit the front cover into the grooves of the back cover. 7. Secure both sides of the front cover to the chassis with the provided screws. To Lock the Access Door From the factory the access door for the reset switch will not be locked. To lock the access door follow the steps below: 1. Locate the lock tab on the back of the front cover and remove the screw securing the tab to the cover. 2. Turn the tab 180 degrees, then secure with the screw. The access door can now be locked. Manual Disconnect Handle Step 12 Install Warning Signs Installers MUST install the UL required warning signs. The signs MUST be installed in plain view on both sides of each gate installed. Use the fastening holes in each corner to permanently secure the sign. Factory Default Position Top (Cludge) Cover Lock Tab Access Door (back of front cover) The basic installation is complete. Place warning signs on both sides of the gate in clear view 24