LiftMaster HDSW24UL Installation Manual - English - Page 8
Operator Specifications, External Entrapment Protection Device Inputs
View all LiftMaster HDSW24UL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
INTRODUCTION Operator Specifications Usage Classification Main AC Supply System Operating Voltage Accessory Power Solar Power Max Maximum Gate Weight/Length 90 Degree Travel Time Maximum Travel Range Maximum Daily Cycle Rate Maximum Duty Cycle Operating Temperature External Entrapment Protection Device Inputs (non-contact and/or contact) Class I, II, III, & IV 120 Vac, 4 Amps (10 Amps including Accessory Outlets) OR 240 Vac, 2 Amps When Optional Transformer Kit Model 3PHCONV is installed in the field, operator is rated 208/240/480/575 VAC, 5.2/4.5/2.3/1.9 A, 60 Hz, 1 PH 24 Vdc Transformer Run / Battery Backup 24 Vdc, 1A max. for ON + SW (switched) 24 Vdc at 60 watts max. 14 ft. - 2,800 lbs. 16 ft. - 2,400 lbs. 18 ft. - 2,200 lbs. 20 ft. - 1,800 lbs. 22 ft. - 1,500 lbs. To optimize performance and extend operator life, the long arm kit model HDLGARM is recommended when installing with gates 16 ft. or longer. See Accessories page 53. When HDLGARM is used, operator has the following maximum gate weight/length: 14 ft. - 4,500 lbs. 16 ft. - 3,750 lbs. 18 ft. - 3,250 lbs. 20 ft. - 2,750 lbs. 22 ft. - 2,500 lbs. 13-36 seconds NOTE: Travel time will vary based on arm configuration and speed control settings. 115 degrees NOTE: Travel range will very based on arm configuration. Continuous Continuous Without Heater: -20°C to 60°C (-4°F to 140°F) With Optional Heater: -40°C to 60°C (-40°F to 140°F) Main board - up to 2 close entrapment protection devices and 1 open entrapment protection device. Expansion board - up to 3 entrapment protection devices configurable to either the close or open direction and up to 8 edge sensors when using the wireless edge sensor kit model LMWEKITU and LMWETXU. 1.31" (3.3 cm) 12.2" (31 cm) 27.85" (70.7 cm) 14" (35.6 cm) 16.77" (42.6 cm) 14.82" (37.6 cm) 8