Home » LiftMaster Manuals » Garage Door Openers » LiftMaster HDSW24UL » Manual Viewer

LiftMaster HDSW24UL Installation Manual - English - Page 50

REPAIR PARTS, Set the WALL XFMR/SOLAR switch to SOLAR.

View all LiftMaster HDSW24UL manuals

Add to My Manuals
Save this manual to your list of manuals

Page 50 highlights

SOLAR PANELS Wire the Solar Panels and Batteries 24W min. - 60W max. for solar applications. NOTE: 33AH batteries are strongly recommended for optimal solar performance. 1. Connect (+) wire from solar panels to (+) pin on CHARGE IN connector on control board. 2. Connect (-) wire from solar panels to (-) pin on CHARGE IN connector on Control board. 3. Set the WALL XFMR/SOLAR switch to SOLAR. Red Wire Jumper Black Wire Red Wire Jumper Black Wire Red wire from battery harness 33AH, HD Gates K41-0102-000 Set Switch to SOLAR 33AH Batteries Black wire from battery harness 33AH, HD Gates K41-0102-000 Control Board 7AH Batteries Battery Wiring 20W APPLICATION IN SERIES 40W APPLICATION IN SERIES 60W APPLICATION IN SERIES 10W 10W 10W 10W 20W 20W 10W 10W 20W 20W 10W 10W 50 10W 10W 10W 10W 10W 10W

Section	Page
INSTALLATION MANUAL	1
TABLE OF CONTENTS	2
SAFETY	2
Safety Symbol and Signal Word Review	2
Usage Class	3
UL325 Entrapment Protection Requirements	3
Safety Installation Information	3
Role of Dealers, Installers, and Trained Gate System Technicians	5
Role of End Users/Home Owners	5
Gate Construction Information	5
1. General Requirements	6
2. Specific Applications	6
3. Vehicular Horizontal Swing Gate	6
INTRODUCTION	7
Carton Inventory	7
Operator Specifications	8
Site Preparation	9
Check your gate	9
INSTALLATION	10
Types of Installations	10
Step 1 Determine Location for Concrete Pad and Operator	11
Step 2 Concrete Pad and Operator Attachment	13
Step 3 Position the Gate Bracket	14
Step 4 Adjust the Operator Arm Length	14
Step 5 Secure the Operator Arm	15
Step 6 Install Entrapment Protection	16
Step 7 Earth Ground Rod	18
Step 8 Power Wiring	18
Step 9 Connect Batteries	20
Step 10 Dual Gate setup	22
Step 11 Install the Cover	24
Step 12 Install Warning Signs	24
ADJUSTMENT	25
Limit, Speed, and Force Adjustment	25
Introduction	25
Set the Initial Limits, Speed, and Force	25
Speed Control	26
Fine Tune the Force	26
Adjust the Limits	27
Obstruction Test	27
PROGRAMMING	28
Remote Controls (Not Provided)	28
LiftMaster Internet Gateway (not provided)	29
CAPXL Connected Access Portal	29
Erase All Codes	30
Erase Limits	30
Constant Pressure Override (CPO)	30
Gate Hold Open Feature	30
To Remove and Erase Monitored Entrapment Protection Devices	30
OPERATION	31
Gate Operator Setup Examples	31
Control Board Overview	31
Manual Disconnect	33
Reset Switch	33
Relay Adapter Board and Terminal Block Access	33
Operator Alarm	33
Remote control	34
ACCESSORY WIRING	34
External Control Devices	34
Locks	36
Miscellaneous Wiring	36
EXPANSION AND RELAY ADAPTER BOARDS	37
Expansion and Relay Adapter Boards Overview	37
Auxiliary Relays	37
Wiring Accessories to the Expansion Board	38
MAINTENANCE	39
Maintenance Chart	41
Batteries	41
TROUBLESHOOTING	42
Diagnostic Codes	42
Control Board LEDs	42
Troubleshooting Chart	44
SOLAR PANELS	46
Step 8 Solar Panel(s)	47
REPAIR PARTS	50
ACCESSORIES	51
Entrapment Protection	51
Remote Controls	52
Miscellaneous	53
Batteries	53
WARRANTY	53
APPENDIX	54
SAMS Wiring with Relays Not Energized	54
Dual Gate Settings	55
Limit Setup with a Remote Control	57
Wiring Diagram	58
Diagnostic Codes Table	59
Swing and Slide Gate Operator UL 325 and ASTM F2200 Site Planning Safety Checklist	60
GETTING STARTED WITH SWING AND SLIDE GATE OPERATORS.	62
Contact Information	64