Linksys SGE2000 Cisco SGE2000, SGE2000P Gigabit Ethernet Switch Reference Guid - Page 213
Mapping DSCP to Queue, Configuring Bandwidth, Quality of Service, General, DSCP to Queue, DSCP
UPC - 745883572120
View all Linksys SGE2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 213 highlights
Chapter SGE2000/SGE2000P Gigabit Ethernet Switch Reference Guide 12 Mapping DSCP to Queue The DSCP to Queue Page enables mapping DSCP values to specific queues. To map DCSP to Queues: 1. Click Quality of Service > General > DSCP to Queue. The DSCP to Queue Page opens: DSCP to Queue Page The DSCP to Queue Page contains the following fields: • DSCP In - Indicates the Differentiated Services Code Point value in the incoming packet. • Queue - Maps the DSCP value to the selected queue. 2. Define the relevant fields. 3. Click Apply. DSCP to queues are mapped, and the device is updated. Configuring Bandwidth The Bandwidth Page allows network managers to define the bandwidth settings for a specified egress interface. Modifying queue scheduling affects the queue settings globally. The Bandwidth page is not used with the Service mode, as bandwidth settings are based on services. Queue shaping can be based per queue and/or per interface. Shaping is determined by the lower specified value. The queue shaping type is selected in the Bandwidth Page. 1. Click Quality of Service > General > Bandwidth. The Bandwidth Page opens: Chapter 12: Configuring Quality of Service 205 Defining General Settings