Marantz SR4400 User Guide - Page 31
General Malfunction, How To Reset The Unit
View all Marantz SR4400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
ENGLISH SYMPTOM CAUSE REMEDY Can not select CSII mode. Input signal is incompatible. Use PCM input signal or analog input signal. No output to Sub Woofer Out. Sub-woofer = NONE has been selected Select Sub-woofer = YES. in SETUP mode. Noise is produced during DTS- Analog has been selected for input. Be sure to perform digital connection, select digital encoded CD or laser disc play. input, then play. A specific channel does not Nothing recorded on source. produce output. Check the encoded channel on the source side. FM or AM reception fails. Antenna connection is incomplete. Correctly connect the indoor FM and AM antennas to FM and AM antenna outlets. Noise is heard during AM Reception is affected by other electrical Try changing location where the AM indoor reception. fields. antenna is set up. Noise is heard during FM The radio waves from the broadcasting Install an FM outdoor antenna. reception. station are weak. Cannot get programmed Preset data has been erased. station when the PRESET button is pressed. Disconnecting power plug for long periods of time will erase preset data. If that happens, input the preset data again. Control with the remote control Batteries are consumed. Replace all the batteries with new ones. unit fails. Remote controller's function-key Select different position from which equipment will setting is wrong. be controlled. The distance between this SR4400 and Move closer to this SR4400. the remote commander is too far. Something is blocking SR4400 and the Remove offending object. remote commander. GENERAL MALFUNCTION If the equipment malfunctions, this may be because an electrostatic discharge or AC line interference has corrupted the information in the equipment memory circuits. Therefore: - disconnect the plug from the AC line supply - after waiting at least three minutes, reconnect the plug to the AC line supply - re-attempt to operate the equipment HOW TO RESET THE UNIT AV SURROUND RECEIVER SR4400 SURROUND VOLUME DOWN UP CLEAR MEMORY TUNING/PRESET F/P MODE STANDBY POWER ON/STANDBY PHONES A/D HT-EQ S-DIRECT DISPLAY MUTE 6.1 CH-IN TV DVD VCR1 DSS/VCR2 CDR/MD TAPE CD TUNER Memory backup • In case a power outage occurs or the power cord is accidentally unplugged, the SR4400 is equipped with a backup function to prevent memory data such as the preset memory from being erased. Should the operation or display seem to be abnormal, reset the unit with the following procedure. The SR4400 is turned on, press and hold the CLEAR and MEMORY buttons simultaneously for 3 seconds or more. Remember that the procedure will reset the settings of the function selector, Surround mode, delay time, TUNER PRESET etc., to their initial settings. 29