Maytag MDB6709AWQ User Instructions - Page 4

STEP 2 Add Detergent NOTE: If you do not plan A to run a wash cycle soon, run a rinse cycle. Do not use detergent. B • Use automatic dishwasher detergent only. Add powder, liquid or tablet detergent just before starting a cycle. • Fresh automatic A. Cover latch B. Main Wash section dishwasher detergent results in better C. Pre-Wash section cleaning. Store tightly closed detergent container in a cool, dry place. • The amount of detergent to use depends on: How much soil remains on the items - Heavily soiled loads require more detergent. The hardness of the water - If you use too little in hard water, dishes won't be clean. If you use too much in soft water, glassware will etch. Soft to Medium Water (0-6 grains per U.S. gallon) [typical water softener water and some city water] Medium to Hard Water (7-12 grains per U.S. gallon) [well water and some city water] • Depending on your water hardness, fill the Main Wash section of the dispenser as shown. Fill the Pre-Wash section to the level shown, if needed. NOTE: For most water conditions, the factory setting of 2 will give good results. If you have hard water or notice rings or spots, try a higher setting. Turn the arrow adjuster inside the dispenser by either using your fingers or inserting a flat-blade screwdriver into the center of the arrow and turning. STEP3 Select a Cycle (cycles vary by model) See "Cycle and Option Descriptions" charts in the following section. Heavier cycles and options affect cycle length. Some cycles and options will take up to 31/2hours to complete. Select Options (options vary by model) See "Cycle and Option Descriptions" charts in the following section. You can customize your cycles by pressing the options desired and press Start/Resume. STEP4 aNrOe TfoEr: sFtaillndaamrdounptoswdsheorewdn X __ HardWater il HardWater Start or Resume a Cycle detergent. Follow X instructions on the package when using other dishwasher detergent. Add Rinse Aid J I s°ftwater MainWash Pre-Wash NOTE: For portable models, see the "Dishwasher Features" section for instructions on how to connect the water and electrical supply. • Run hot water at the sink nearest your dishwasher until the water is hot. Turn off water. Your dishwasher is designed to use rinse aid for good drying performance. Without rinse aid your dishes and dishwasher interior will have excessive moisture. The heat dry option will not perform as well without rinse aid. IME _'] Full • Push door firmly closed. The door latches automatically. Select the wash cycle and options desired and press START/RESUME OR press START/ RESUME to repeat the same cycle and options as in _t2_o • Rinse aid keeps water from forming droplets that can the previous wash cycle. dry as spots or streaks. It also improves drying by allowing water to drain off of the dishes after the final rinse. kW_AJdd • You can add an item anytime before the main wash starts. Open the door slowly and add the item. Close the door firmly. Press the START/RESUME button, the cycle resumes Rinse aid helps to reduce excess moisture on the dish racks automatically at the point of interruption. and interior of your dishwasher. Check the rinse aid indicator. Add rinse aid when indicator For fully integrated models (controls on top of console) drops to "Refill" level. • Select the wash cycle and options desired. To add rinse aid, turn the dispenser cap counterclockwise and lift off. Pour rinse aid into the opening until the indicator window looks full. Replace the dispenser cap and turn clockwise. Make sure cap is fully locked. USE RINSEAIDFOR Full OpenBETTER_:__LDoRcYk ING ! • Press the START/RESUME button once and close the door. After a brief pause, the cycle will begin. The door must be closed within 3 seconds after pushing START/RESUME or the lights will flash, and the dishwasher will not begin. Press the START/RESUME button again and shut the door within 3 seconds. You can add an item anytime before the main wash starts. Open the door slowly and add the item. Press the START/RESUME then close the door. turn to lock