Maytag MDB6709AWQ User Instructions - Page 6

OPTIONS DISH LOAD TYPES DESCRIPTIONS USE WITH: Heated dry Heated dry: For best drying drying resu!ts, dry dishes t h heat: To sanitize your dishes and glassware in accordance with NSF/ANSI Standard 184 for Residential Dishwashers. Turn OFE When loads contain plastic dinnerware that maybe sensitive to high temperatures I This option with the use of rinse aid Wi!l provide the best performance. Raises the water temperature in the final rinse to approximately 154°F (68°C). This high temperature rinse sanitizes your dishes and glassware in accordance with NSF/ANSI Standard 184 for Residential Dishwashers. Certified residential dishwashers are not intended for licensed food establishments. The Sanitize option adds heat and time to the cycle. Light, Auto C!ean P!us .......... Heavy, Normal, Light, or Auto Clean Plus :_ j_ ,_ integrated To run .youi dishwasher at aate.r, t me or dur ng off - Peak nours. Control Lock To avoid unintended use of your dishwasher, or cycle and option changes during a cycle. De!ays the start oia Cyc!e up to6 hours Ai! CYcles Select a wash cycle and options Press Delay. Press START/ RESUME. Close the door firmly within 3 seconds. For fully m0dels ((contro!s ontop 0f c0nso!e), To turn on Lock, press and hold Heated Dry for at least 3 seconds. To turn off Lock, press and hold Heated Dry for at least 3 seconds. When Control Lock is lit, all buttons are disabled. If you press any pad while your dishwasher is locked, the light flashes 5 times. The dishwasher door can be opened while the controls are locked. Anytime IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the cycle for the best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle will automatically compensate by adding time, heat and water as needed. CONTROL PURPOSE To start or resume a wash cycle COMMENTS If the do0r is opened during a CYcle or the power is interrupted, a!l lights Will flash to indicate a suspended CYC!e.The cyc!e will not resume until the door is c!osed, and the START/RESUME button is pushed _ _cancel drain To cancel wash cycle Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher drain completely. ci_n_ _,,!,i_ wash dry clean To follow the progress:and status oTyour a snwasner cYCle The !tclean,i indicator glows when a cycle is finished. If you select the sanitize option;when the Sanitize cYc!e is finished, the Sanitized indicat0r g!ows: If your dishwasher did not properly sanitize your dishes, the light will be blinking. This can happen if the cycle is interrupted, or the water could not be heated to the required temperatu[el The clean and sanitize !ights go Off when the d0or has been opened for rnore than 30 seconds or the CANCEL key is pressed. The !!Washing,' indicator glows at the start of the first fill of any cYCle (except Rinse On!y)and remains on until the end of the main wash cycle. The "Drying" indicator glows during the drying portion of each cycle (except Rinse Only).