McAfee M-2750 Product Guide - Page 18
Remove the power supply, Cable the Sensor, See also - console
View all McAfee M-2750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
3 Setting up the Sensor Cable the Sensor 3 Place the power supply in the slot with the cable outlet facing front and on the left side of the faceplate. Figure 3-3 Power supply units of the Sensor 4 Slide in the power supply until it makes contact with the backplane, then push firmly to mate the connectors solidly with the backplane. For true redundant operation with the optional redundant power supply, McAfee recommends that you plug each supply into a different power circuit. For optimal protection, use uninterruptable power sources. Remove the power supply Note that the power supplies are hot-swappable. To avoid data interruption, do not power off both power supplies on an in-line Sensor, else the Sensor shuts down and all data traffic stops. Power off only the power supply you are replacing. Task 1 Unplug the power cable from its power source and remove the power cable from the power supply. 2 Put on an antistatic wrist or ankle strap. 3 Attach the strap to a bare metal surface of the chassis. 4 Push the release latch inward toward the handle. 5 Squeeze the handle of the power supply and pull it out. 6 Use faceplate panels to protect unused slots from dust and reduce electromagnetic radiation. 7 Replace the mounting bracket. To remove all power from the Sensor, unplug all power cords. Cable the Sensor Follow the steps outlined in Attaching Cables to the Sensor to connect cables to the monitoring, response, console, and management ports on your Sensor. See also Attaching cables to the Sensor on page 3 18 McAfee® Network Security Platform M-2750 Sensor Product Guide