Motorola LS2208-SR20007R User Manual - Page 161

Chapter 12 Symbologies Introduction This chapter describes all symbology features and provides programming bar codes for selecting these features for the Symbol LS2208 scanner. Before programming, follow the instructions in Chapter 1, Getting Started. The scanner ships with the settings in the Symbology Default Table on page 12-2 (also see Appendix A, Standard Default Parameters for all host device and miscellaneous scanner defaults). If the default values suit requirements, programming is not necessary. To set feature values, scan single bar codes or short bar code sequences. To return all features to default values, scan Set All Defaults on page 4-3. If you are not using a Synapse or USB cable, you must select a host type. See each host chapter for specific host information. Scanning Sequence Examples In most cases, scan one bar code to set a specific parameter value. For example, to transmit bar code data without the UPC-A check digit, scan the Do Not Transmit UPC-A Check Digit bar code under Transmit UPC-A/UPC-E/UPC-E1 Check Digit on page 12-13. The scanner issues a fast warble beep and the LED turns green, signifying a successful parameter entry. Other parameters, such as Set Length(s) for D 2 of 5 require scanning several bar codes in sequence. See the individual parameter, such as Set Length(s) for D 2 of 5, for this procedure. Errors While Scanning Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.