NEC LCD4010-BK LCD4010 external control command - Page 14

Monitor ID: Specify the Monitor ID which you want to get a value. Ex.) If Monitor ID is '1', specify 'A'. '0' (30h): Message sender is the controller 'C' (43h): Message Type is "Get parameter " '0'-'6' (30h, 36h): Message length is 6 bytes Message STX (02h): Start of Message '0'-'2' (30h, 32h): Operation code page number is 02h. '7'-'9' (37h, 39h): Operation code is 79h (in the page 2) ETX (03h): End of Message Check code BCC: Block Check Code Refer to the section 4.5 "Check code" for a BCC calculation. Delimiter CR (0Dh): End of packet Step 4. The monitor replies a temperature of selected sensor. Header Message Check code SOH-'0'-'0'-Monitor ID-'D'-'1'-'2' STX-'0'-'0'-'0'-'2'-'7'-'9'-'0'-'0' BCC -'0'-'0'-'F'-'F'-'0'-'0'-'3'-'2'-ETX Header SOH (01h): Start of Header '0' (30h): Reserved '0' (30h): Message receiver is the controller Monitor ID: Indicate a replying Monitor ID. Ex.) When this byte is set to 'A', the replying Monitor ID is '1'. 'D' (44h): Message Type is "Get parameter reply" '1'-'2' (31h, 32h): Message length is 18 bytes Message STX (02h): Start of Message '0'-'0' (30h, 30h): Result code. No error '0'-'2' (30h, 32h): Operation code page number is 2 '7'-'9' (37h, 39h): Operation code is 79h (in the page 2) '0'-'0' (30h, 30h): This operation is "Set parameter" type '0'-'0'-'F'-'F' (30h, 30h, 46h, 46h): Maximum value. '0'-'0'-'3'-'2' (30h, 30h, 33h, 32h): The temperature is 25 degrees Celsius. Readout value is 2's complement. Temperature [Celsius] +125.0 + 25.0 + 0.5 0 - 0.5 - 25.0 - 55.0 Readout value Binary 0000 0000 1111 1010 0000 0000 0011 0010 0000 0000 0000 0001 0000 0000 0000 0000 1111 1111 1111 1111 1111 1111 1100 1110 1111 1111 1001 0010 Hexadecimal 00FAh 0032h 0001h 0000h FFFFh FFCEh FF92h ETX (03h): End of Message Check code BCC: Block Check Code Refer to the section 4.5 "Check code" for a BCC calculation. Delimiter CR (0Dh): End of packet Delimiter CR (14/37)