NEC LCD4010-BK LCD4010 external control command - Page 28
Self diagnosis
UPC - 805736012224
View all NEC LCD4010-BK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
'B' (42h): Message type is "Command reply" '0'-'C' (30h, 43h): Message length. Message STX (02h): Start of Message 'C'-'2'-'1'-'5' (43h, 32h, 31h, 35h): Schedule writes command ST: Schedule Status command 0(30h):No error 1(31h):Error PG-EN: Schedule data PG: Program No. '0'-'0'(30h, 30h): Program No.1 | '0'-'6'(30h, 36h): Program No.7 EN: Enable /Disable '0'-'0'(30h, 30h): Disable '0'-'1'(30h, 31h): Enable ETX (03h): End of Message Check code BCC: Block Check Code Refer to the section 4.5 "Check code" for a BCC calculation. Delimiter CR (0Dh): End of packet 11. Self diagnosis 11.1 Self-diagnosis status read This command is used in order to read the Self-diagnosis status. 1) The controller requests the monitor to read Self-diagnosis status. Header Message Check code SOH-'0'-Monitor ID-'0'-'A'-'0'-'4' STX-'B'-'1'-ETX BCC Delimiter CR Header SOH (01h): Start of Header '0' (30h): Reserved Monitor ID: Specify the Monitor ID which you want to get status. Ex.) If Monitor ID is '1', specify 'A'. '0' (30h): Message sender is the controller 'A' (41h): Message type is "Command" '0'-'4'(30h, 34h): Message length. Message STX (02h): Start of Message 'B'-'1' (42h, 31h): Self-diagnosis command ETX (03h): End of Message Check code BCC: Block Check Code Refer to the section 4.5 "Check code" for a BCC calculation. Delimiter CR (0Dh): End of packet 2) The monitor replies a result of the self-diagnosis. Header SOH-'0'-'0'-Monitor ID-'B'-N-N Message STX-'A'-'1'ST(0)-ST(1) --------ST(n)-ETX Check code Delimiter BCC CR Header SOH (01h): Start Of Header '0' (30h): Reserved '0' (30h): Message receiver is the controller (28/37)