Netgear FVL328 FVL328 Reference Manual - Page 151
Appendix C Preparing Your Network, What You Will Need Before You Begin, LAN Hardware Requirements
UPC - 606449025811
View all Netgear FVL328 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 151 highlights
Appendix C Preparing Your Network This appendix describes how to prepare your network to connect to the Internet through the FVL328 Prosafe High Speed VPN Firewall and how to verify the readiness of broadband Internet service from an Internet service provider (ISP). Note: If an ISP technician configured your computer during the installation of a broadband modem, or if you configured it using instructions provided by your ISP, you may need to copy the current configuration information for use in the configuration of your firewall. Write down this information before reconfiguring your computers. Refer to "Worksheet for Recording Your Internet Connection Information" on page C-3" for further information. What You Will Need Before You Begin You need to prepare these three things before you can connect your firewall to the Internet: 1. A computer properly connected to the firewall as explained below. 2. Active Internet service such as that provided by a DSL or Cable modem account. 3. The Internet Service Provider (ISP) configuration information for your account. LAN Hardware Requirements The FVL328 Firewall connects to your LAN via twisted-pair Ethernet cables. To use the FVL328 Firewall on your network, each computer must have an installed Ethernet Network Interface Card (NIC) and an Ethernet cable. If the computer will connect to your network at 100 Mbps, you must use a Category 5 (CAT5) cable such as the one provided with your firewall. The broadband modem must provide a standard 10 Mbps 10BASE-T or 100 Mbps 100BASE-T Ethernet interface. Preparing Your Network C-1 May 2004, 202-10030-02