Netgear MCA1001 MCA1001 User Guide - Page 38

Configuring the Coax Settings, Password, Administrative Password, Apply

Get Netgear MCA1001 - MoCA Coax-Ethernet Adapter PDF manuals and user guides View all Netgear MCA1001 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 38 highlights

Coax-Ethernet Adapter MCA1001 User Manual 1. Select Password under Setup in the main menu. The Password screen displays. Figure 3-9 2. In the Administrative Password fields, enter between 4 and 8 characters (no spaces) for your new password, then confirm it by entering it again. 3. Click Apply to save your password setting. Note: If you forget your password, use a pen to press the Reset button located on the back of your Coax-Ethernet Adapter to factory default settings by holding it longer than 10 seconds; if LEDs are on, the Ethernet and Coax traffic LEDs will go off to indicate when the Coax-Ethernet Adapter has finished resetting. Configuring the Coax Settings Note: Usually the default settings do not need to be changed, unless Technical Support has specifically instructed you to adjust them. You may want to change these settings for the following reasons: 3-12 Managing Your MCA1001 Coax-Ethernet Adapter Network v1.0, December 2008

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
Coax-Ethernet Adapter MCA1001 User Manual
3-12
Managing Your MCA1001 Coax-Ethernet Adapter Network
v1.0, December 2008
1.
Select
Password
under Setup in the main menu. The Password screen displays.
2.
In the
Administrative Password
fields, enter between 4 and 8 characters (no spaces) for your
new password, then confirm it by entering it again.
3.
Click
Apply
to save your password setting.
Configuring the Coax Settings
You may want to change these settings for the following reasons:
Figure 3-9
Note:
If you forget your password, use a pen to press the Reset button located on the back
of your Coax-Ethernet Adapter to factory default settings by holding it longer than
10 seconds; if LEDs are on, the Ethernet and Coax traffic LEDs will go off to
indicate when the Coax-Ethernet Adapter has finished resetting.
Note:
Usually the default settings do not need to be changed, unless Technical Support
has specifically instructed you to adjust them.