Netgear WFS709TP WFS709TP Hardware manual - Page 17
GE Uplink Port, Serial Console Port
UPC - 606449052336
View all Netgear WFS709TP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
WFS709TP ProSafe Smart Wireless Switch Hardware Installation Guide The LED states are listed in order of precedence (highest to lowest). If more than one AP is connected to the port, the state with the highest precedence is displayed. GE Uplink Port 3 The WFS709TP ProSafe Smart Wireless Switch provides one Gigabit Ethernet (GE) 10/100/1000 Mbps 1000BASE-T copper port for high-bandwidth connection between the switch and the wired LAN. The port automatically senses and negotiates speed, duplex, and MDI/MDX settings. Figure 1-3 shows the following callouts: • Gigabit Ethernet port 1 • LNK/ACT LED, which provides the following information: 2 Status Description Off Green Flashing Green No Ethernet link on the port. An Ethernet link has been established on the port, but no data is currently being transmitted or received. The port is transmitting or receiving data. The flashing rate is proportional to your network activity. Figure 1-3 See "GE Uplink Port" on page A-2 for cable specifications. Note: The Gigabit interface is not user-replaceable. Do not remove the port cover plate. Serial Console Port 4 Use this port to connect a local management console. This connection can be used to access the text-based command-line interface (CLI) for initial configuration of the WFS709TP. Introduction 1-5 v1.0, May 2007