Netgear WFS709TP WFS709TP Hardware manual - Page 29
Appendix A Cables and Connector Pinouts, Fast Ethernet Network Ports, RJ-45 Pinouts, Cables
UPC - 606449052336
View all Netgear WFS709TP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Appendix A Cables and Connector Pinouts This appendix describes cables and connector pinouts for ports on the WFS709TP ProSafe Smart Wireless Switch. Fast Ethernet Network Ports RJ-45 Pinouts The RJ-45 female connector pinouts are shown in Figure A-1: Figure A-1 Cables The type of cable required for each port depends on the device being connected. Note: Refer to the document Installation Guide: ProSafe Wireless Access Point for information about specific power requirements. • Direct connection to a POE-compatible device This requires a 4- or 8-conductor Category 5 UTP Ethernet cable with an RJ-45 male connector. A straight-through cable is required to preserve POE voltage polarity. Cables and Connector Pinouts A-1 v1.0, May 2007
Cables and Connector Pinouts
A-1
v1.0, May 2007
Appendix A
Cables and Connector Pinouts
This appendix describes cables and connector pinouts for ports on the WFS709TP ProSafe Smart
Wireless Switch.
Fast Ethernet Network Ports
RJ-45 Pinouts
The RJ-45 female connector pinouts are shown in
Figure A-1
:
Cables
The type of cable required for each port depends on the device being connected.
•
Direct connection to a POE-compatible device
This requires a 4- or 8-conductor Category 5 UTP Ethernet cable with an RJ-45 male
connector. A straight-through cable is required to preserve POE voltage polarity.
Figure A-1
Note:
Refer to the document
Installation Guide: ProSafe Wireless Access Point
for
information about specific power requirements.