Netgear WG302 WG302v1 Reference Manual - Page 35
Configuring Wireless Settings, Default Gateway, Primary and Secondary DNS Servers - and vlans
UPC - 606449030365
View all Netgear WG302 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
NETGEAR ProSafe 802.11g Wireless Access Point WG302 Reference Manual - Default Gateway: Enter the IP address of your LAN Gateway. For more complex networks, enter the address of the router for the network segment to which the wireless access point is connected. The default is 0.0.0.0. - Primary and Secondary DNS Servers: Enter the IP address of the Domain Name Server (DNS) you wish to use. The default is 0.0.0.0. 4. Spanning Tree Protocol. Enable or disable spanning tree protocol. Spanning tree protocol provides network traffic optimization in settings with multiple ProSafe 802.11gs. The default is Enabled. 5. Enable 802.1Q VLAN. Check the radio box to accept 802.1Q VLAN to allow the WG302 to process VLAN membership. The default is disabled. 6. From the pull-down men, select the local Time Zone setting for your location. 7. Check the Adjust for Daylight Saving Time if your location uses daylight saving. The default is no adjustment. Note: You must have an Internet connection to get the current time. 8. Click Apply so save your Basic IP settings. Configuring Wireless Settings To configure the wireless settings of your wireless access point: 1. Click Wireless Settings under Setup in the main menu of the browser interface. The Basic Wireless Settings menu will appear, as shown below. Basic Installation and Configuration v4.0, April 2006 2-11