Netgear WG302 WG302v1 Reference Manual - Page 83
Troubleshooting, No lights are lit on the access point.
UPC - 606449030365
View all Netgear WG302 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
Chapter 5 Troubleshooting This chapter provides information about troubleshooting your ProSafe 802.11g Wireless Access Point . After each problem description, instructions are given to help you diagnose and solve the problem. For the common problems listed, go to the section indicated. • Is the WG302 on? • Have I connected the wireless access point correctly? Go to "Installing the ProSafe 802.11g" on page 2-4. • I cannot remember the wireless access point's configuration password. Go to "Changing the Administrator Password" on page 3-12. Note: For up-to-date WG302 installation details and troubleshooting guidance visit http://kbserver.netgear.com/products/WG302.asp If you have trouble setting up your WG302, check the tips below. No lights are lit on the access point. It takes a few seconds for the power indicator to light up. Wait a minute and check the power light status on the access point. If the access point has no power. • Make sure the power cord is connected to the access point. • Make sure the power adapter is connected to a functioning power outlet. If it is in a power strip, make sure the power strip is turned on. If it is plugged directly into the wall, verify that it is not a switched outlet. • Make sure you are using the correct NETGEAR power adapter supplied with your access point. 5-1 v4.0, April 2006