Nokia NBB0150000 Installation Guide - Page 58

5 To enable IKE acceleration 1. From the Network Voyager home page, click Security and Access Configuration, then click IKE Acceleration. For information about how to access Network Voyager and the related reference materials, see "Using Nokia Network Voyager" on page 35. 2. On the IKE Acceleration page, click Register the module. 3. Click Apply. The PKCS#11 token that enables IKE acceleration is registered with the Check Point software on your appliance. After you register the module, you must install the Check Point security policy on the firewall for the Nokia encryption accelerator card to perform IKE acceleration. Replacing the Battery Caution To protect the appliance from electrostatic discharge damage, make sure you are properly grounded before you touch these components. Use a grounding wrist strap and follow the instructions provided with the wrist strap before you handle the components or open the appliance. If you do not have a grounding wrist strap, make sure you are properly grounded before you touch any electronic component. You must perform an orderly shutdown of the appliance and turn the power off whenever you remove the chassis tray assembly to service internal components. To replace the battery, you need the following: „ The appropriate Nokia battery replacement kit for your appliance „ Physical access to the appliance „ A Phillips-head screwdriver „ A grounding wrist strap „ (Optional) Safety glasses Warning Risk of explosion if battery is replaced by an incorrect type. Replace the battery only with the same or equivalent type that the manufacturer recommends. Dispose of used batteries according to the manufacturer's instructions. Warning Make certain to remove the power cord from the appliance before you proceed with any of the following steps. Failure to do so could cause electric shock with burns or death resulting for the user. 58 Nokia IP150 Security Platform Installation Guide