NordicTrack Elite 5000 Instruction Manual - Page 43

SYMPTOM: The digital TV is not receiving a signal a. Make sure that the correct input source is selected. See step 2 on page 35 to select an input source. the signal is weak, the picture may be of poor quality or a blue screen may appear. If the signal is weak, it may be necessary to install an external antenna to improve the picture. b. Make sure that the antenna cable or CATV cable is connected securely to the treadmill. See page 18 to connect a CATV cable to your fitness equipment. c. Scan for broadcast or cable signals. See step 4 on page 38 to scan for signals. d. Due to an FCC requirement, analog signals are no longer broadcast over the air in the United States as of June 12, 2009. If you wish to view television signals through an antenna, you must have an antenna capable of receiving digital signals. Cable television has not been affected. SYMPTOM: Digital TV reception is poor a. Make sure that the digital TV settings are set correctly. See HOW TO ADJUST THE TV SETTINGS on page 38. b. For the digital TV to operate properly, good reception is necessary. If you are using an antenna, make sure that it is properly connected and adjusted for optimal reception. See HOW TO CONNECT AN ANTENNA on page 18. c. Check for the problems listed below and follow the applicable instructions: • Ignition (black spots or horizontal streaks that appear or a picture that flutters or drifts)- Usually this is caused by interference from automobile ignition systems, neon lamps, electric drifts, or other electric appliances. Try changing the position of your fitness equipment or other electric appliances to correct the problem. • Ghosts-Ghosts are caused by the TV signal following two paths-one is the direct path and the other is reflected from tall buildings, hills, or other objects. Change the direction or position of the antenna to improve reception. • Fading-If blocks of the picture are missing, the picture moves around the screen, or the picture disappears, the signal may be weak. Change the direction or position of the antenna to improve reception. Make sure the digital TV settings are set correctly (see HOW TO ADJUST TV SETTINGS on page 38). Do not use a splitter. Note: If one of these problems appears when the cable from a CATV company is connected, the problem may be caused by the cable company broadcast. SYMPTOM: The digital TV needs to be cleaned a. UNPLUG THE POWER CORD. To clean the digital TV, wipe the digital TV and screen using a soft cloth with a small amount of soft detergent. Do not use a polishing cloth, solvent, or any type of propellant or chemical detergent such as alcohol or benzene. SYMPTOM: The speed ring does not connect to the console a.  Straighten a paper clip, and press the end into the indicated a Paper Clip opening in the back of the speed ring. This will reset the speed ring. b. If the speed ring still does not connect, unplug the treadmill power cord, wait for five minutes, and then plug the power cord back in. • Blue Screen-If your fitness equipment is located in the fringe area of a TV station where 43