NordicTrack Freestride Trainer Fs7i Elliptical Uk Manual - Page 25

MAINTENANCE AND TROUBLESHOOTING MAINTENANCE Regular maintenance is important for optimal performance and to reduce wear. Inspect and properly tighten all parts each time the elliptical is used. Replace any worn parts immediately. To clean the elliptical, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. CONSOLE TROUBLESHOOTING If the console does not turn on, make sure that the power cord is fully plugged in. If the console does not display your heart rate when you use the chest heart rate monitor, see TROUBLESHOOTING on page 10. HOW TO LEVEL THE ELLIPTICAL If the elliptical rocks slightly on your floor during use, see HOW TO LEVEL THE ELLIPTICAL on page 12. INCLINE SYSTEM TROUBLESHOOTING If the frame does not move to the correct incline level, see step 4 on page 23 and calibrate the incline system. HOW TO ADJUST THE DRIVE BELT If the pedals slip while you are pedaling, even while the resistance is adjusted to the highest level, the drive belt may need to be adjusted. To adjust the drive belt, first unplug the power cord. Next, remove the M4 x 16mm Screw (98) and the Access Cover (24) from the Right Inner Shield (21). Then, tighten the M10 x 80mm Screw (131) until the Drive Belt (72) is tight. 21 24 98 131 72 When you have properly adjusted the Drive Belt (72), reattach the Access Cover (24). 25