NordicTrack Incline Trainer X7i Treadmill English Manual - Page 11

L L 5. Have a second person hold the console assembly near the Uprights (77). Insert the console wire and the “"R”" pulse wire from the console assembly through the indicated tie. Connect the Upright Wire (78) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CONNECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER. Remove the wire tie from the Upright Wire (78). 5 78 77 Tie R “"R”" Pulse Wire Console Assembly Console Wire Wire Tie Console Wire 78 6. Insert the Upright Wire (78) into the right Upright (77) as you insert the Console Crossbar (101) into the Uprights. Be careful not to pinch the Upright Wire. Loosen the four #8 x 1" Screws (102) (only two are shown) one turn. Tighten two 5/16" x 2 1/2" Screws (4) with two 5/16" Star Washers (9) into the side of the right Upright (77) and into the Crossbar (103). Do not overtighten the Screws. Be careful not to pinch the Upright Wire (78). Next, tighten two 5/16" x 5/8" Screws (11) into the right Upright (77) and the Console Crossbar (101). It may be necessary to slide the Console Crossbar to align the holes. Then, tighten the two #8 x 1" Screws (102). Attach the left Upright (not shown) to the Console Crossbar (101) on the other side of the incline trainer as described above. 6 101 78 4 9 77 102 R 103 11 11