NordicTrack S3000 Treadmill English Manual - Page 24

5. SYMPTOM: THE SURFACE OF THE WALKING PLATFORM IS DAMAGED a. Both sides of the walking platform are designed to be used as walking surfaces. If the surface becomes damaged, or if there is any wood showing through the coating, the walking platform can be turned over. The walking platform typically needs to be turned over after approximately 6,000 to 7,500 miles (10,000 to 12,000 kilometers). Follow the instructions below to turn over the walking platform. Remove the key and unplug the power cord. Remove the two Hood Screws (2) and lift off 1 2 the Motor Hood (1). Next, re- move the two Rear Roller Bolts (82), the two Roller Guard Screws (80), and the Right and 80 83 6 6 Left Roller Guards (81, 83). 82 Remove the six Platform 80 70 Screws (6). Lift the Rear Roller (79) and slide it out of the Walking Belt (71). Lift the 81 6 82 Walking Platform (70) a few inches, slide it out of the Walking Belt, turn it over, and 71 79 then slide it back into the Walking Belt. Slide the Rear Roller back into the Walking Belt. Reattach the six Platform Screws (6). Reattach the Right and Left Roller Guards (81, 83) with the two Roller Guard Screws (80). Insert the Rear Roller Bolts (82) into the Roller Guards and thread them into the Rear Roller (79). Reattach the Motor Hood (1) with the two Hood Screws (2). Next, the Walking Belt (71) will need to be adjusted to the proper tension. Using chalk, make two marks exactly 71 50 in. (127 cm) apart on the Walking Belt as shown in the drawing. Then, tighten both Rear Roller Bolts (82) until the two chalk marks move apart an additional 3/16 50" to 1/4 in. (0.5 to 0.64 cm). Make sure to keep the Walking Belt centered. 82 24