Oki C9300n C9300/C9500 User's Guide: Macintosh - Page 174
Changing the transfer belt, and place them on
View all Oki C9300n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 174 highlights
CHANGING THE TRANSFER BELT When the transfer belt reaches the end of its life, CHANGE BELT UNIT is displayed in the control panel. The transfer belt life is approximately 80,000 sheets, letter long edge feed. However, this assumes a standard print job of three sheets. If single sheets are printed, transfer belt life is reduced. 1. Switch off the printer and open the top cover. 2. Remove all four image drums/toner cartridges from the printer and place them on a flat surface (to prevent damage to the shiny green drum surface), then cover them to protect them from light while you are replacing the transfer belt. C9300/C9500 Maintenance • 172
C9300/C9500 Maintenance • 172
CHANGING THE TRANSFER BELT
When the transfer belt reaches the end of its life,
CHANGE BELT UNIT
is displayed in the control panel. The transfer belt life is
approximately 80,000 sheets, letter long edge feed. However, this
assumes a standard print job of three sheets. If single sheets are
printed, transfer belt life is reduced.
1.
Switch off the printer and open the top cover.
2.
Remove all four image drums/toner cartridges from the printer
and place them on a
flat
surface (to prevent damage to the shiny
green drum surface), then
cover them to protect them from light
while you are replacing the transfer belt.