Olympus 262010 E-3 Instruction Manual (English) - Page 75
Using the external electronic flash
UPC - 050332160569
View all Olympus 262010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
Functions available with external flash units Optional flash FL-50R FL-50 FL-36R FL-36 FL-20 RF-11 TF-22 Flash control mode TTL-AUTO, AUTO, MANUAL, FP TTL AUTO, FP MANUAL TTL-AUTO, AUTO, MANUAL TTL-AUTO, MANUAL GN (Guide number) (ISO100) GN50 (85 mm*) GN28 (24 mm*) GN36 (85 mm*) GN20 (24 mm*) GN20 (35 mm*) GN11 GN22 RC mode 9 k 9 k k k k * The focal length of the lens that can be used (Calculated based on 35 mm film camera) x Notes • The FL-40 optional flash cannot be used. Using the external electronic flash Be sure to attach the flash to the camera before turning on the flash's power. 1 Remove the hot shoe cover by sliding it in the direction indicated by the arrow in the illustration. • Keep the shoe cover in a safe place to avoid losing it, and put it back on the camera after flash shooting. Hot shoe cover 2 Attach the electronic flash to the hot 6 shoe on the camera. Flash shooting • If the lock pin is protruding, turn the shoe lock ring as far as it will go in the direction opposite to LOCK. This will pull the lock pin back inside. Lock pin Lock ring 3 Turn on the flash. • When the charge lamp on the flash lights up, charging is complete. • The flash will be synchronized with the camera at a speed of 1/250 sec. or less. 4 Select a flash mode. 5 Select the flash control mode. • TTL-AUTO is recommended for normal use. 6 Press the shutter button halfway. • Shooting information such as ISO sensitivity, aperture value, and shutter speed is communicated between the camera and flash. 7 Press the shutter button all the way. x Notes • The built-in flash cannot be used when an external flash is attached to the hot shoe. 75 EN