Panasonic CF72VCJUZQM CF72V3JUZQM User Guide - Page 21

Dealing with Problems (Summary) When a problem occurs, refer to this page. The "Reference Manual" also contains detailed information. If a problem appears to be related to a software application, read the software related manual. If you still cannot troubleshoot the problem, contact Panasonic Technical Support. Starting Up The power indicator or battery indicator is not lit is displayed Check the cable connection for the AC adaptor. Check to see if a fully charged battery is properly installed. Remove the battery pack and disconnect the AC adaptor, then connect them again. Input your password. If you have forgotten it, contact Panasonic Technical Support. POST Startup Error(s) is displayed Windows startup, or an operation is extremely slow The date and time are incorrect When the previous item is not the cause When resuming from the standby or hibernation mode, does not appear even if a password has been set in the Setup Utility The password of the administrator is forgotten page 19 Press F9 in the Setup Utility ( "Setup Utility"). This will restore the Setup Utility's settings to their default values (except the password settings). Then, the Setup Utility must be run once again for you to input the appropriate operating environment set- tings. (The processing speed depends on the application software used, so this operation may not cause the processing speed to increase.) You can set the date and time using the following menu. Windows 2000 : [Control Panel] - [Date/Time] Windows XP : [Control Panel] - [Date, Time, Language, and Regional Options] [Date and Time] When the computer is connected to a LAN, confirm the date and time of the server. If you continue to experience problems, the internal battery maintaining the clock may need to be replaced. Contact Panasonic Technical Support. This computer will not correctly recognize the date and time starting from the year 2100 A.D. Press F9 in the Setup Utility ( "Setup Utility"). This will restore the Setup Utility's settings to their default values (except the password settings). Try removing all peripheral devices. Windows 2000 Click [Local Disk(C:)] in [My Computer] with the right button, select [Properties], then select [Tools] - [Check Now]. Windows XP Click [Local Disk(C:)] in [Start] - [My Computer] with the right button, select [Proper- ties], then select [Tools] - [Check Now]. At start-up, press F8 to operate the computer in the Safe mode. Use the Windows password as follows: Windows 2000 Set the password in [Control Panel] - [Users and Passwords], then add the check mark for [Prompt for password when computer goes off standby] in [Control Panel] - [Power Options] - [Advanced]. Windows XP Select the account to change in [Control Panel] - [User Accounts] and set the password, then add the check mark for [Prompt for password when computer resumes from standby] in [Control Panel] - [Performance and Maintenance] - [Power Options] - [Advanced]. Windows 2000 After reinstalling, setup Windows and then set the password again. Windows XP If you have created a password reset disk ( page 12), a message is displayed when you fail to correctly enter the password. Follow the message's instructions and set the password again by using the password reset disk. If you have not created a password reset disk, after reinstalling, setup Windows and then set the password again. Troubleshooting 21