Panasonic CF72VCJUZQM CF72V3JUZQM User Guide - Page 3
Read Me First
View all Panasonic CF72VCJUZQM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Read Me First Getting Started For U.S.A. Federal Communications Commission Radio 2. An FCC compliant telephone cord and modular plug is pro- Frequency Interference Statement vided with this equipment. This equipment is designed to be connected to the telephone network or premises wiring using Note: This equipment has been tested and found to comply with a compatible modular jack which is Part 68 compliant. See the limits for a Class B digital device, pursuant to Part 15 of the Installation Instructions for details. FCC Rules. These limits are designed to provide reasonable 3. The REN is used to determine the quantity of devices which protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the Panasonic Service Center or an experienced radio/TV technician for help. may be connected to the telephone line. Excessive RENs on the telephone line may result in the devices not ringing in response to an incoming call. In most, but not all area, the sum of RENs should not exceed five (5.0). To be certain of the number of devices that may be connected to a line, as determined by the total RENs, contact the local telephone company. 4. If your telephone equipment cause harm to the telephone network, the telephone company will notify you in advice that temporary discontinuance of service may be required. But if advice notice isn't practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary. 5. The telephone company may take changes in it's facilities, equipment, operations or procedures that could affect the operation of the equipment. If this happens the telephone company will provide advance notice in order for you to make Warning To assure continued compliance, use only shielded interface cables when connecting to a computer or peripheral. Also, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. FCC RF Exposure Warning: This computer is provided with PC Card slots that could be used with wireless transmitter(s), which will be specifically recommended, when they become necessary modifications to maintain uninterrupted service. 6. If trouble is experienced with this equipment, for repair or warranty information, please contact Matsushita Electric Corporation of America at DIAL TOLL FREE 1-800-LAPTOP5 (1-800-527-8675). If the equipment is causing harm to the telephone network, the telephone company may request that you disconnect the equipment until the problem is resolved. 7. There are no user serviceable parts contained in this equipment. 8. This equipment may not be used on coin service provided by the telephone company. Connection to party lines is subject available. Other third-party wireless transmitter(s) have not been to state tariffs. RF exposure evaluated for use with this computer and may not 9. The Telephone Consumer Protection Act of 1991 makes it un- comply with FCC RF exposure requirements. lawful for any person to use a computer or other electronic This device complies with Part 15 of the FCC Rules. Operation device to send any message via a telephone fax machine un- is subject to the following two conditions: less such message clearly contains in a margin at the top or (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Responsible Party: Matsushita Electric Corporation of America bottom of each transmitted page or on the first page of the transmission, the date and time it is sent and an identification of the business or other entry, or other individual sending the message and the telephone number of the sending machine or such business, other entity, or individual. In order to program One Panasonic Way this information into your fax software, you should refer to Secaucus, NJ 07094 the manual of the Fax software being used. Tel No:1-800-LAPTOP-5 (1-800-527-8675) 10.According to the FCC's electrical safety advisory, we recom- mend that you may install an AC surge arrestor in the AC outlet FCC Regulation Notice for modem This equipment contains a FCC approved modem. Manufacturer of modem: AMBIT Microsystems Corporation Model No. J07.017.C.00 Tested To Comply to which this equipment is connected. Telephone companies report that electrical surges, typically lightning transients, are very destructive to customer terminal equipment connected to AC power sources and that this is a major nationwide problem. "Caution: To reduce the risk of fire, use only No.26 AWG or larger telecommunication line cord." With FCC Standards FOR HOME OR OFFICE USE "ATTENTION: Pour réduire le risque d'incendie, utiliser uniquement des conducteurs de télécommunications 26 AWG ou de section supérieure." 1. This equipment complies with Part 68 of the FCC rules. On Notice for the products using LCD the computer is a label that contains, among other informa- This product uses one or more fluorescent lamps containing a tion, the FCC registration number and ringer equivalence small amount of mercury. It also contains lead in some compo- number (REN) for this equipment. If required, this informa- nents. Disposal of these materials may be regulated in your com- tion must be provided to the telephone company. munity due to environmental considerations. For disposal or re- cycling information please contact your local authorities, or the Electronics Industries Alliance: 3