Panasonic SA-XR57K Receiver - Page 23

Changing remote control codes Two or more Panasonic audio equipment may start functioning when you use the unit's remote control for operating the equipment. Switch the unit's remote control code to "REMOTE 2 " in such cases. Use the same code for setting the unit and its remote control through the following steps. INPUT SELECTOR MENU SETUP ENTER RETURN SS Y TUNE HDMI MENU SETUP INPUT SELECTOR ENTER RETURN VOLUME Enter a code to operate some equipment This remote control can operate Panasonic and Technics audio-visual equipment that has remote control sensors. You may need to change the remote control code. It can also operate some other brands of televisions, video cassette recorders, and DVD players. Check the table for the brand and enter the code as follows. Changing the codes Code table TV VCR DVD player TV VCR PLAYER DVD ANALOG 6CH Press and hold the button corresponding to the equipment. Before use INPUT SELECTOR Basic operation Turn to make a choice. 0 Enter the first digit. ENTER Press to confirm your choice. MENU SETUP RETURN To return to the previous display/ To cancel Operation on the main unit 1 Enter the setup. MENU Press and hold SETUP for approximately 2 seconds. RETURN 2 Select and confirm the setting. 3 Select and confirm the setting. 0 Enter the second digit. The remote control outputs the on/off signal. If the code is correct, the equipment turns on or off. If it doesn't, try entering another code. • Note that this remote control cannot operate some equipment and that it may not be able to perform some operations. • Re-enter the codes after you change the batteries. 4 Press [-MENU, -SETUP, RETURN] to select "EXIT " and press [ENTER]. Operation on the remote control TUNER 5 Press BAND 6 Press ENTER and simultaneously and hold them in the position for approximately 2 seconds. When you return the remote control code to "1" • Operation on the main unit: select "1" in step 3. • Operation on the remote control: press [ENTER] and [1] simultaneously and hold them in the position for approximately 2 seconds or longer in step 6. Remote controlling a TV or DVD recorder etc. Basic operations 23 RQT8549