Panasonic SAHT830V SAHT830V User Guide - Page 40

The radio [Remember] Press [TUNER] first. Press [TUNER] to put the remote control in TUNER mode. TV INPUT SELECTOR DVD/VHS FM/AM DVD VHS TV TUNER Numbered buttons 123 CH 45 6 PICTURE MODE 78 VOLUME 9 SETUP ENTER DISC 0 S10 SKIP SLOW/SEARCH OPEN/CLOSE/EJECT JET REW FM/AM TUNER CH CH VOLUME ENTER H.BASS C. FOCUS SFC SHIFT PL TOP MENU NAVI DIRECT NAVIGATOR STATUS/ FUNCTIONS ENTER MENU PLAY LIST RETURN TV VOL TV VOL MULTI RE-MASTER MIX 2CH PROGRESSIVE REPEAT QUICK OSD ZOOM CD MODE PLAY MODE H.BASS C.FOCUS TEST CH SELECT SUBWOOFER LEVEL SFC SUPER SRND MUTING ADVANCE QUICK CM SKIP DISC REVIEW REPLAY PROG SPEED SHIFT SLEEP PL AUDIO CANCEL REC RESET TV/VIDEO PLAY MODE CH SELECT TEST SUPER SRND INPUT SELECTOR ∫ Presetting the channel one by one 1 Tune to the station (l above). 2 Press [ENTER]. 3 While "PGM" is blinking on the display Press the numbered buttons to select a channel. Alternatively, press [W CH] or [X CH] then press [ENTER]. PGM The station occupying a channel is erased if another station is preset to that channel. Selecting the preset channels 1 Press [FM/AM] to select "FM" or "AM". 2 Press the numbered buttons to select the channel. Alternatively, press [W CH] or [X CH]. To select a 2-digit number e.g. 12: [S10] l [1] l [2]. OPEN/CLOSE DISC CHECK H.BASS STOP PLAY -DEMO /REW FF/ STOP PLAY PHONES REC CH DOWN EJECT VOLUME UP When a stereo FM broadcast is being received. Automatic presetting Up to 15 stations can each be set in the FM and AM bands. 1 Press [FM/AM] to select "FM". 2 Press [6] or [5] to tune to the lowest frequency ("FM 87.9" MHz or "FM 87.5" MHz). 3 Press and hold [ENTER]. Release the button when "AUTO" is displayed. The tuner presets all the stations it can receive into the channels in ascending order. ≥"SET OK" is displayed when the stations are set. The last station to be set is then played. ≥"ERROR" is displayed when automatic presetting is unsuccessful. Preset the channels manually (l right). 4 Repeat steps 1 to 3 to set the AM bands (the lowest frequency is "AM 520" kHz). Manual tuning 1 Press [FM/AM] to select "FM" or "AM". 2 Press [6] or [5] to select the frequency. Press and hold [6] or [5] until the frequency starts scrolling to start automatic tuning. Tuning stops when a station is found. ST TUNED ∫ If noise is excessive in FM Press [PLAY MODE] to display "MONO". MONO Press [PLAY MODE] again to cancel the mode. The mode is also canceled when you change the frequency. ∫ FM frequency step Main unit only The step is factory-set to 0.2 MHz, but you can change it to receive broadcasts allocated in 0.1 MHz steps. 1 Press [INPUT SELECTOR] on the main unit to select "FM". 2 Press and hold [INPUT SELECTOR]. After a few seconds the display changes to show the current minimum frequency. Continue to hold the button down. The minimum frequency changes and the step is changed. To return to the original step, repeat the above steps. [Note] Any FM/AM frequencies preset in channels will be changed by this procedure. Preset them again. RQT7921 40