Panasonic SAXR700 SAXR700 User Guide - Page 10

Step 3 Set speakers and test speaker output The unit checks each speaker's connection status and make speaker settings automatically. " " SPEAKERS A B AUTO DETECTOR CH 0 DIRECT TUNING DISC XM CAT ENTER VOLUME XM CH SKIP SLOW/SEARCH STOP PAUSE PLAY DRIVE SELECT CM SKIP ONE TOUCH PLAY DIRECT NAVITGOAPTOMRENU FUNCTIONS ENTER SUB MENU RETURN XM DISPLAY SUBWOOFER TV OFF DIMMER LEVEL EFFECT VOL NEO : 6 TV/VIDEO SFC AUTO MUSIC MOVIE TEST MUTING POWER INPUT SELECTOR POWER BI-AMP SURROUND ADVANCED DUAL AMP WIRELESS READY MULTI ROOM -MENU/-SETUP ENTER SURROUND SPEAKERS TUNE RETURN -MENU/-SETUP ENTER SURROUND RETURN AUTO DETECTOR -MULTI ROOM SPEAKERS TUNE AUTO DETECTOR -MULTI ROOM VOLUME AUTO SPEAKER SETUP HDMI SETUP MIC AUX W S VIDEO VIDEO - - L AUDIO R SETUP MIC W AUX Detecting speakers automatically 1 To turn the unit on POWER Press 8 2 To check the speaker presence SPEAKERS A B Press simultaneously. AUTO DETECTOR Automatic speaker detection starts. • The standby indicator "^" goes off when you turn the unit on. The unit checks the center speaker, surround speakers, surround back speakers and the subwoofer in that order. (The connection status for front speakers is always present.) The display shows the number of detected speakers (excluding the subwoofer). (e.g.) The display shows connected speakers. When automatic detection is finished, the display returns to the original. How speakers are displayed L : Front left C : Center R : Front right SB : Surround back W : Subwoofer S : Surround "WARNING " messages may appear on the display depending on detection results. The right surround back speaker was detected, but the unit did not detect the left surround back speaker. Use the terminal for the left speaker when you connect one surround back speaker only (á page 9). The unit did not detect left and right surround speakers. Connect surround speakers as well when you connect surround back speakers to the unit. The unit did not detect one of the two surround speakers. Check speaker connections. Note • Automatic detection does not work well depending on speakers and cables. Make speaker settings manually in such cases (á page 35). • These settings remain effective after the unit goes off. • The unit considers seven speakers and one subwoofer are connected to the unit (keeps factory settings) unless you perform these steps. • Perform the above steps when you connect a new speaker. 10 RQT8739