Panasonic SAXR700 SAXR700 User Guide - Page 36
Changing auto, speaker settings, Making BI-AMP, settings, Setting ADVANCED, DUAL AMP off
View all Panasonic SAXR700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Settings INPUT SELECTOR "BI-AMP" -MENU/-SETUP ENTER RETURN INPUT SELECTOR VOLUME See page 34 for receiver operations. POWER BI-AMP SURROUND ADVANCED DUAL AMP WIRELESS READY MULTI ROOM -MENU/-SETUP ENTER SURROUND SSPPEEAAKKEERRSS TUNE RETURN -MENU/-SETUP ENTER SURROUND RETURN AUTO DETECTOR -MULTI ROOM SPEAKERS TUNE AUTO DETECTOR -MULTI ROOM AUTO SPEAKER SETUP HDMI SETUP MIC AUX W S VIDEO VIDEO - - L AUDIO R SETUP MIC W AUX Changing auto speaker settings 1) Among speaker settings made with the setup microphone, you can return polarity and frequency to factory settings. (The "AUTO SPEAKER SETUP" indicator goes off when you perform this operation.) 2) The unit judges polarity of certain properly connected speakers as opposite. When this happens, set the unit against automatic polarity adjustment and prevent polarity reversal. 1) To return speakers to factory settings 2) Setting the unit against automatic polarity adjustment 1 Select and confirm the choice. 2 Select and confirm the choice. 3 Select and confirm the choice. • To cancel, press "NO ". 1 Select and confirm the choice. 2 Select and confirm the choice. 3 Select and confirm the choice. 1 Select and confirm the choice. YES : For returning to factory settings NO : For keeping auto settings CHECK YES : Normal auto speaker setup CHECK NO : No automatic polarity adjustment Making BI-AMP settings • BI-AMP settings appear on the display and become selectable only when you set bi-wire speakers (á page 20). 1) You can drive speakers with front, surround and surround back speaker amps instead of using BI-AMP (triple amp mode). 2) You can adjust HF (high frequency) and LF (low frequency) output balance of the bi-wired speakers. 3) You can reduce the delay time due to the difference in size of the HF and LF units. 1) Canceling BI-AMP (using the triple amp mode) 2 Select and confirm the choice. 3 Select and confirm the choice. AUTO : When using BI-AMP OFF : When not using BI-AMP (when using the triple amp mode) Factory setting : AUTO • The "BI-AMP" indicator goes off when the unit enters the triple amp mode. 1 Select and confirm the choice. 2) Adjusting the balance 2 Select and confirm the choice. 3 Make adjustment and confirm the choice. The bar shows the standard balance. 3) Correcting the HF and LF difference (Side view of a speaker in cross section) Difference 1 Select and confirm the choice. 2 Select and confirm the choice. 3 Make adjustment and confirm the choice. in LF : Low frequency HF : High frequency Adjustment range: 0.0 to 12.0 in (inch) You can select differences at 0.5 inch intervals. Factory setting: 0.0 in (inch) Setting ADVANCED DUAL AMP off 36 RQT8739 1 Select and confirm the choice. 2 Select and confirm the choice. AUTO : Advanced dual amp is on OFF : Advanced dual amp is off Factory setting: AUTO