Panasonic SVAV50 Sd Movie - Page 40

Recording Pictures supplied from an external device 1 Turn the SD Video Camera off and put in the USB Cradle. (l 10) 2 Connect the [AV IN/OUT] terminal of the USB Cradle to the AV Output Sockets of the DC IN 4.8V external device 2 using supplied AV Cable 1. 3 Turn on the SD Video Camera and set the Record/Play mode Switch to [ ] and AV IN/OUT 2 then, set the operation mode to [PICTURE] or [MPEG4]. 4 Press the [MENU] Button and then, select 1 [Setup] and press the Jog Ball. 5 Set [Input select] to [Line] and press the [MENU] Button. ≥The [ ] indication appears. 6 Select desired image quality. (l 22, 24) 7 Press the [MENU] Button. 8 Set up the external device. ≥Confirm that the image or sound signal is input 3 2 MODE into the SD Video Camera. ≥In the [MPEG4] mode, when rotating the Zoom 4 Lever to [W], you can mute the sound from the speaker. (The volume of the sound cannot be Ô changed. You can output the sound again when MENU rotating the Zoom Lever to [T].) 9 Press the Recording Start/Stop Button. ≥Recording starts. ≥When the moving picture is being recorded, 5,6 Ô × MENU press the Recording Start/Stop Button again to stop recording. × 5672 ≥While this camera can record audio from an external $GGR 1HH device, the audio connection should only be +PRWVUGNGEV .KPG connected to the "line" output of the external device. ų#WVQRQYGTQP 1HH 7 This is normally an "RCA" type of connector. Do not attempt to connect audio directly from the MENȕUǩȸȞȃȈ speaker output of any device. Doing so will cause serious damage to this device. 9 40