Panasonic SVAV50 Sd Movie - Page 57
NOTES AND HINTS, When the Battery Level Indicator
UPC - 037988251193
View all Panasonic SVAV50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Flashing approx. every 1 second (flashes on approx. 0.5 seconds and off approx. 0.5 seconds): ≥The SD Video Camera, battery or AC adaptor may be defective. Contact your nearest Panasonic dealer. Flashing approx. every 12 seconds (flashes on approx. 6 seconds and off approx. 6 seconds): ≥The ambient temperature or that of the battery itself is too high or too low. Charging proceeds, but will take a longer time. Turning off: Charging is completed. ≥If the Power Lamp turns off when charging is not completed, the AC Adaptor or the battery is probably defective. Contact your nearest Panasonic dealer. Notes and Hints ª Charging the Battery (l 11) ≥When the Battery Level Indicator indicates [ ], the battery will run out in a few minutes. Recharge the battery. ≥It takes approx. 100 minutes, maximum for full-charging. (The charging times are for normal ambient temperature (77 °F (25 °C) /60%). If the Battery is charged at a higher or lower temperature, the charging time may be longer.) ≥The capacities of the recording time/ playback time/still picture storage with a supplied, full-charged battery are as follows (77 °F (25 °C) /60%): Number of Recordable Still Pictures (PICTURE) (When recording still pictures with setting the [Picture size] to [1600 k 1200] and [Quality] to 120 still pictures [Normal] every 30 seconds, activating flash every other recording.) Maximum Continuous Recording Time (MPEG4) 60 min. Maximum Continuous Playback Time (MPEG4) 75 min. Maximum Continuous Voice Recording Time (VOICE) 120 min. Maximum Continuous Music Playback Time (AUDIO) (When the [Power save] function is 120 min. activated.) The times/number of images listed in the above table are approximate. ≥Be sure to detach the battery after use. ≥If you disconnect the DC Input Lead or the AC Main Lead while charging the Battery, Power Lamp flashes several times and goes off. For continuing Battery charge, wait for approx. 1 minute, and then connect the AC Main Lead and the DC Input Lead. ≥It is recommended to set the battery even when using the AC adaptor. ≥The main unit becomes hot when it is being charged or used. This is normal. 57